Scribd
Upload
211 views4 pages

USB Dongle Setup Instructions

- The document provides instructions for setting up a new CR system that involves connecting USB devices to a computer. - When a new USB device is first connected, a "Found New Hardware" window will appear and ask to install device software automatically. - It identifies 3 common dongles that may be connected - for scanner models, for image processing licenses, and for connecting the scanner. - A 7 step process is outlined for installing each device's software drivers the first time it is plugged in.

Uploaded by

uriel vazquez
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
211 views4 pages

USB Dongle Setup Instructions

- The document provides instructions for setting up a new CR system that involves connecting USB devices to a computer. - When a new USB device is first connected, a "Found New Hardware" window will appear and ask to install device software automatically. - It identifies 3 common dongles that may be connected - for scanner models, for image processing licenses, and for connecting the scanner. - A 7 step process is outlined for installing each device's software drivers the first time it is plugged in.

Uploaded by

uriel vazquez
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 4

Important Instructions setting up your new CR system.

When you first connect a new USB device to your computer the “Found New Hardware” window will
appear on your screen. You will receive this message each time a new USB device is plugged into
the computer. This message will only appear the first time you insert the USB device or if the USB
device is inserted into a different USB port.

Identify the dongles that have been connected when you insert them into your computer

"WIBU-BOX/U"
This dongle is only present with POC 140
scanner models.

"USB UltraPro"
Also identified as "Rainbow USB SuperPro."
This is the ContextVision dongle,
it contains the license for image processing.

"USB Device"
Also identified as "Kodak Point of Care"
This is the USB cable that connects
the scanner to your computer.

Version 1
Step 1: Step 2:
Insert the USB device(s) and the following window will Enter the following...
appear... User name: hardware
Password: hardware
Click OK

Step 3:
You will be asked if you would like to connect to Windows Update to search for software.
Select the option "No, not this time"
Click "Next >" to continue.
Step 4:
You will be asked what you would like the "Found New Hardware Wizard" to do.
Select the option "Install the software automatically (Recommended)"
Click "Next >" to continue.

Step 5:
If the USB device you inserted was identified as "USB Device" or "Kodak Point of Care" you will
see the prompt below. Click on "Continue Anyway."
If you did not see this prompt, continue to step 6.
Step 6:
If the software for the USB driver was installed correctly you will see the window below.
Click on "Finish."
You have finished installing the device.

Step 7:
If you inserted multiple USB devices at the same time, the Found New Hardware Wizard window will
appear again, once for each USB device plugged into the computer.
You will need to repeat the procedure starting from Step 2.

You might also like