Scribd
Upload
94 views2 pages

DCS Torch Wire Feeder

The document describes setting up a user model by enabling different elements as line segments or cylinders of specific sizes, and defining offsets for their positions. It involves selecting a torch angle and wire feeder, then enabling 4 elements as geometric shapes and setting position details to define the model.

Uploaded by

arturo
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
94 views2 pages

DCS Torch Wire Feeder

The document describes setting up a user model by enabling different elements as line segments or cylinders of specific sizes, and defining offsets for their positions. It involves selecting a torch angle and wire feeder, then enabling 4 elements as geometric shapes and setting position details to define the model.

Uploaded by

arturo
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 2

User Model Enable element 1 as a 75mm Line_seg, press Blue objects encapsulating the torch

detail and define the Pos1 and Pos2 offsets represent User Model definitions
- Fronius Torch 22°
- Wire feeder
Select User model setup
and press Detail

Enable element 2 as a 20mm Line_seg, press Enable element 4 as a 175mm Line_seg, press
detail and define the Pos1 and Pos2 offsets detail and define the Pos1 and Pos2 offsets

Define Model 1

Enable element 3 as a 20mm Cylinder, press Blue objects encapsulating the Wire Feeder
detail and define the Pos1 and Pos2 offsets represent User Model definitions

Detail
User Model Enable element 1 as a 75mm Line_seg, press Blue objects encapsulating the torch
detail and define the Pos1 and Pos2 offsets represent User Model definitions
- Fronius Torch 45°
- Wire feeder
Select User model setup
and press Detail

Enable element 4 as a 175mm Set Link No 3


Enable element 2 as a 20mm Line_seg, press
Line_seg, press detail and define thePos1 and
detail and define the Pos1 and Pos2 offsets
Pos2 offsets

Define Model 1

Enable element 3 as a 20mm Cylinder, press Blue objects encapsulating the Wire Feeder
detail and define the Pos1 and Pos2 offsets represent User Model definitions

Detail

You might also like