Scribd
Upload
46 views

AWS Steel Structures Costs and Dates

The document provides information about an ASME Code of Construction course. The course is suitable for welding inspectors, project engineers, and those seeking Inspector of Pressurised Equipment certification. It covers the requirements of ASME sections I, VIII, and IX, as well as the National Board Inspection Code. The course will be held in Johannesburg, Durban, and Cape Town, with sessions running from February to November.

Uploaded by

Ehab Attia Selim
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
46 views

AWS Steel Structures Costs and Dates

The document provides information about an ASME Code of Construction course. The course is suitable for welding inspectors, project engineers, and those seeking Inspector of Pressurised Equipment certification. It covers the requirements of ASME sections I, VIII, and IX, as well as the National Board Inspection Code. The course will be held in Johannesburg, Durban, and Cape Town, with sessions running from February to November.

Uploaded by

Ehab Attia Selim
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 1

Please contact course administrator on [email protected].

za – 011 298 2111 for further information

This ASME Code of Construction is ideal for welding inspectors


involved in boiler and/or pressure vessel fabrication, repair
or modification according to the ASME codes. This course is
mandatory for inspectors aiming for Inspector of Pressurised
Equipment (IPE) certification with the intention of working for an
Approved Inspection Authority.
The course is also suitable The course addresses the requirements reports; pressure relief devices; duties
for project and maintenance of ASME Section 1 – rules of of inspectors; using the codes and
construction calculations; practical solutions to
engineers and engineering for power boilers. ASME section VIII problems.
supervisors with responsibility Division 1 – rules of construction for
for boilers and pressure vessels pressure vessels, ASME Section IX – Successful graduates will have an
as an introduction to the ASME welding and brazing qualifications and appreciation for the design requirements
codes. NBIC – National Board Inspection Code. and be able to use the codes and
interpret and apply the fabrication and
Candidates should have a Grade 10 The following syllabus with an emphasis inspection requirements in their daily
qualification as a minimum with 12 on code requirements for welding, work activities.
months welding inspection experience. fabrication and inspection: design of
Candidates should preferably have vessels and boilers; allowable materials;
completed the SAIW level 2 welding strengthen calculations for openings;
inspector qualification prior to doing this fabrication requirements; qualification
course, which is a requirement for IPE of welders and welding procedures; CPD credits available for
certification. Inspection and tests; marking and this course

Course Schedule

JOHANNESBURG | DURBAN | CAPE TOWN


HOURS JHB 1 JHB 2 JHB 3 DBN 1 DBN 2 CPT 1 CPT 2

ASME VIII
ASME I
80 04 - 15 Feb 08 - 19 Jul 11 - 22 Nov 11 - 22 Feb 14 - 25 Oct 20 - 31 May 04 -15 Nov
ASME IX
NBIC

Examination (2 x 4 hrs) 8

Please note that any comments, compliments or complaints related to:


43
1. Training can be forwarded to [email protected] 2. E
 xamination and Certification can be forwarded to [email protected]

You might also like