Scribd
Upload
42 views

Example of Coordinates System

The document describes three coordinate systems - absolute, relative, and relative polar. It provides examples of commands to draw a line using each system. The absolute system uses Cartesian (x,y) coordinates to specify points. The relative system uses offsets from the previous point (@x,y). The relative polar system specifies the distance and angle (@DIST<ANGLE) from the previous point. It also lists the 'C' and 'U' options to close or undo a line series.

Uploaded by

Amer Gonzales
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
42 views

Example of Coordinates System

The document describes three coordinate systems - absolute, relative, and relative polar. It provides examples of commands to draw a line using each system. The absolute system uses Cartesian (x,y) coordinates to specify points. The relative system uses offsets from the previous point (@x,y). The relative polar system specifies the distance and angle (@DIST<ANGLE) from the previous point. It also lists the 'C' and 'U' options to close or undo a line series.

Uploaded by

Amer Gonzales
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
You are on page 1/ 1

EXAMPLE OF COORDINATES SYSTEM:

Draw the figure start from the


original point (0,0)..

Absolute Coordinate System(X,Y)


Command:Line
Specify first point:0,0
Specify next point:10,0
Specify next point:10,8
Specify next point:8,8
Specify next point:8,2
Specify next point:6,2
Specify next point:6,8
Specify next point:4,8
Specify next point:4,2
Specify next point:2,2
Specify next point:2,8
Specify next point:0,8
Specify next point:0,0 or C
Relative Coordinate System(@X,Y)
Command:Line
Specify first point:0,0
Specify next point:@10,0
Specify next point:@0,8
Specify next point:@-2,0
Specify next point:@0,-6
Specify next point:@-2,0
Specify next point:@0,6
Specify next point:@-2,0
Specify next point:@0,-6
Specify next point:@-2,0
Specify next point:@0,6
Specify next point:@-2,0
Specify next point:@0,-8 or C
Relative Polar Coordinate System(@DIST<ANGLE)
Command:Line
Specify first point:0,0
Specify next point:@10<0
Specify next point:@8<90
Specify next point: @2<180
Specify next point: @6<270
Specify next point: @2<180
Specify next point: @6<90
Specify next point: @2<180
Specify next point: @6<270
Specify next point: @2<180
Specify next point: @2<180
Specify next point: @6<90
Specify next point: @2<180
Specify next point: @8<270 or C.
Options:
 C: this option close series of lines, connect first point with last point by line.
 U: enter U for undo. AutoCAD backs up one segment, undoing it so that you
can recreate it.

You might also like