Scribd
Upload
125 views1 page

TolerancesAlign PDF

The document provides specifications for acceptable and excellent tolerances for offset and angularity measurements in inches and millimeters for short flexible couplings and spacer shaft and membrane couplings at different RPMs. It also lists a tolerance for soft foot measurements for all RPMs.

Uploaded by

Alexis Cordova
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
125 views1 page

TolerancesAlign PDF

The document provides specifications for acceptable and excellent tolerances for offset and angularity measurements in inches and millimeters for short flexible couplings and spacer shaft and membrane couplings at different RPMs. It also lists a tolerance for soft foot measurements for all RPMs.

Uploaded by

Alexis Cordova
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 1

RPM inch (mils) metric (mm)

Acceptable Excellent Acceptable Excellent

Short “flexible” couplings

Offset: 600 9.0 5.0


750 0.19 0.09
900 6.0 3.0
1200 4.0 2.5
1500 0.09 0.06
1800 3.0 2.0
3000 0.06 0.03
3600 1.5 1.0
6000 0.03 0.02
7200 1.0 0.5

Angularity:
600 15.0 10.0
Inch: Gap difference per 750 0.13 0.09
10 inch coupling diameter 900 10.0 7.0
(divide by 10 for mils/1”) 1200 8.0 5.0
1500 0.07 0.05
1800 5.0 3.0
Metric: Gap difference per 3000 0.04 0.03
100 mm coupling diameter 3600 3.0 2.0
(divide by 100 for mm/mm) 6000 0.03 0.02
7200 2.0 1.0

Spacer shafts and


membrane (disc)
couplings

Inch: Offset per inch 600 3.0 1.8


spacer shaft 750 0.25 0.15
Metric: Offset per 100 mm 900 2.0 1.2
spacer shaft 1200 1.5 0.9
1500 0.12 0.07
1800 1.0 0.6
3000 0.07 0.04
3600 0.5 0.3
6000 0.03 0.02
7200 0.03 0.02

Soft foot All RPMs 0.06 2

* Tolerances provided by PRUFTECHNIK Alignment

You might also like