Scribd
Upload
59 views13 pages

Creo 5.0 Installation

This document provides instructions for installing Creo 5.0 software at NJIT. It outlines the steps to connect to the NJIT VPN, download and unzip the Creo installation file, run the setup as an administrator, enter the license server information during installation, customize the installation to include various Creo modules like Direct Modeling Converter and Layout, and complete the installation process. Key steps include activating the NJIT VPN, right-clicking to run setup.exe as administrator, checking options during customization, and clicking Finish to complete.

Uploaded by

sravan
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
59 views13 pages

Creo 5.0 Installation

This document provides instructions for installing Creo 5.0 software at NJIT. It outlines the steps to connect to the NJIT VPN, download and unzip the Creo installation file, run the setup as an administrator, enter the license server information during installation, customize the installation to include various Creo modules like Direct Modeling Converter and Layout, and complete the installation process. Key steps include activating the NJIT VPN, right-clicking to run setup.exe as administrator, checking options during customization, and clicking Finish to complete.

Uploaded by

sravan
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 13

Creo 5.

0 Installation
By: Dr. Herli Surjanhata

Before you install, you must have NJIT VPN as shown below,

 Activate VPN – see figure below.

Click Connect and enter your UCID and Password.

Click OK.

Now you are connected to webvpn.njit.edu and start to install Creo 5.0

Download Creo 5.0 file and if necessary unzip it to destination folder.

Navigate to installation folder,

1
Right-click setup.exe of Creo 5.0 and select Run as administrator.

The PTC Installation Assistant dialog box appears.

2
Click

3
Be sure to check and see below.

and then click .

4
Under License Summary section.

Enter [email protected] for Source. The installation will connect to the license server and
Available is displayed under Status box.

5
Be sure the status of your license server is Available. Click .

Click on Customize … button. Application Custom Setting dialog box appears.

Note that Creo Direct is highlighted and check Direct Modeling Converter.

6
Highlight Creo Layout

7
Highlight Creo Parametric and check the ALL for Options, API Toolkits and Interface as shown below.

8
Highlight Creo Simulate and check the setting as shown below.

9
Click .

10
Note:

If you want to install Mathcad, check PTC Mathcad option as shown below.

11
Click on the PTC Installation Assistant.

The installation in progress figures are shown below.

Check both Public networks and Public networks.

12
Click to complete the installation.

13

You might also like