Scribd
Upload
148 views5 pages

Honda Civic 18 20 TypeR PDF

This document provides instructions for connecting a flat cable to an ECU for a Honda Civic 1.8 2.0 Type R. It states to connect the red wire from the cable to the two red pins on the ECU plug for power, and the black wire to the two black pins for ground. It also shows pictures of how to desolder the pins on the flat cable, flip the cable over, and bridge certain pins in order to write to the ECU.

Uploaded by

Fabian Carrasco Naula
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
148 views5 pages

Honda Civic 18 20 TypeR PDF

This document provides instructions for connecting a flat cable to an ECU for a Honda Civic 1.8 2.0 Type R. It states to connect the red wire from the cable to the two red pins on the ECU plug for power, and the black wire to the two black pins for ground. It also shows pictures of how to desolder the pins on the flat cable, flip the cable over, and bridge certain pins in order to write to the ECU.

Uploaded by

Fabian Carrasco Naula
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 5

ECU : Honda Civic 1.8 2.

0 TypeR

Connect as below:
Serial Suite: ECU Plug:

Red to 2 Pins Red (Power Supply +12 Volt)


Black to 2 Pins Black (Ground)

Piasiniengineering [email protected] – http://www.piasiniengineering.it


Tel: +39 0342 489060 - Fax: +39 0342 488298
Where to connect the flat cable:

This are the pins where to connect the flat cable.

Piasiniengineering [email protected] – http://www.piasiniengineering.it


Tel: +39 0342 489060 - Fax: +39 0342 488298
How to connect the flat cable for READ the ECU

Piasiniengineering [email protected] – http://www.piasiniengineering.it


Tel: +39 0342 489060 - Fax: +39 0342 488298
How to connect the flat cable for Write the ECU
Desoldering all pin of flat cable.Then turn in the otherside the ecu.

Picture 1

Put a wire(bridge)
like in the picture.

Piasiniengineering [email protected] – http://www.piasiniengineering.it


Tel: +39 0342 489060 - Fax: +39 0342 488298
Picture 2

Connect the flat cable following the number like in the picture, and put a wire(bridge)
like in the picture.

Piasiniengineering [email protected] – http://www.piasiniengineering.it


Tel: +39 0342 489060 - Fax: +39 0342 488298

You might also like