UNIT -I

1). 2G standards support ( )

a. Limited internet browsing
b. Short Messaging Service
c. Both a & b
d. None of the above

2). commonly used mode for 3G networks is ( )

a. TDMA
b. FDMA
c. TDD
d. FDD

3). what is the responsibility of MSC in cellular telephone system? ( )

a) Connection of mobile to base stations
b) Connection of mobile to PSTN
c) Connection of base station to PSTN
d) Connection of base station to MSC

4). who set the standards of GSM? ( )

a) ITU
b) AT & T
c) ETSI
d) USDC

5) BCCH (Broadcast Control Channel) frequency is also called _____? ( )

a) Engine
b) Driver
c) Pilot
d) None

6) _____________ are a supplementary services. ( )

a)Caller ID
b) Call hold
c) Call waiting
d) All the above

7). DECT stands for ( )

a. Digital European Cordless Telephone
b. Digitized Emergency Cellular Telephone
c. Digital European Cellular Telex
d. Digital European Cellular Telephone\

8) Why the size of the cell is kept small in cellular network? ( )

a) Increase capacity
b) Decrease capacity
c) Increased size of base station electronics
d) slow process of handoffs

9). An EDGE connection is _____ ? ( )

a)CS data
b) PS data
c) CS and PS data
d) None

10). In Handoff ( )
a. Process of transferring the call to the new base station
b. Transfers the call
c. New channel allocation is done
d. All of the above

11) The basic GSM is based on connection-oriented traffic channels, e.g., with 9.6 kbit/s each,
several channels could be combined to increase bandwidth. This system is called _____.
12) Due to limited bandwidth, it causes connection latency _____ [True/ False].
13) _____ is the interface between a mobile station and a BTS in a GPRS network.
14) Commonly used mode for 3G networks is _____
15) PSTN stands for _____
16) The process of transferring a mobile station from one base station to another is _____
17) A GPRS network is a part of _____ in GSM network.
18) _____ Memory device stores information such as subscriber’s identification number in GSM
19) ISDN provides integrated end user access to only packet switched networks _____ (T/F)
20) ____ manages the switching function in GSM.

Answers
1) C 2) D 3) B 4) C 5) C 6) D 7) A 8) A 9) C 10) D
11) HSCSD {high speed circuit switched data} 12) TRUE 13) Um 14) FDD
15) Public Switched Telephone Network 16) Handoff 17) NSS 18) SIM 19) F
20) NSS
 UNIT – II

1)What is the size of MAC address? ( )

a) 16-bits
b) 32-bits
c) 48-bits
d) 64-bits

2) Which of the following is not true for TDMA? ( )

a) Single carrier frequency for single user
b) Discontinuous data transmission
c) No requirement of duplexers
d) High transmission rates

3) The increased capacity of SDMA due to ( )

a) focused signal transmitted into narrow transmission beams
b) smart antennas pointing towards mobile stations
c) use of different frequencies at same time slot
d) both a) and b) are correct
e) both a) and c) are correct

4) IP was originally designed for ( )

a)Multicast delivery
b)Multilevel cast delivery
c)Unicast delivery
d)Absolute delivery

5) The DHCP server _________ ( )

a) maintains a database of available IP addresses
b) maintains the information about client configuration parameters
c) grants a IP address when receives a request from a client
d) all of the mentioned

6) Frequency planning is very essential in ( )

a) FDMA
b) TDMA
c) FDMA & TDMA
d) None of the mentioned
7) In _____ each station sends a frame whenever it has a frame to send. ( )
a)pure aloha
b)slotted aloha
c)both a & b
d)neither a nor b

8) Which of the following specifies a set of media access control (MAC) and physical layer
specifications for implementing WLANs? ( )
a) IEEE 802.16
b) IEEE 802.3
c) IEEE 802.11
d) IEEE 802.15

9) Frequency division multiple access (FDMA) assigns ______ channels to _______ users. ( )
a) Individual, individual
b) Many, individual
c) Individual, many
d) Many, many

10) Internet has chosen datagram approach to switching in the ( )

a)Data Link Layer
b)Network Layer
c)Physical Layer
d)Presentation Layer

11) _____ describes the mechanism used for forwarding packets between the HA and COA.
12) The process of sending a packet via tunnel and it is achieved by a mechanism called _____.
13) The network layer is concerned with __________ of data.
14) 802.11 wireless networking uses _____ method as the media access method.
15) _____ assigns a unique number to each IP network adapter called the MAC address.
16) DHCP (dynamic host configuration protocol) provides __________ to the client.
17) After obtaining the IP address, to prevent the IP conflict the client may use _________
18) The network layer protocol for internet is __________
19) The FDMA channel carries ____ phone circuit at a time.
20) TDMA systems transmit in a continuous way _____(T/F)
 Answers
1) C 2) A 3) D 4) C 5) D 6) C 7) A 8) C 9) A 10) B
11)Tunneling 12) Encapsulation 13) Packets 14) CSMA/CD 15) MAC
16) IP address 17) Address resolution protocol 18) Internet Protocol
19) one 20) F

UNIT - III

1) What is the purpose of using source & destination port numbers respectively in the addressing
method of transport layer? ( )
a) For Delivery & Reply operations
b) For Reply & Delivery operations
c) Only for Delivery operations
d) Only for Reply operations

2) Bytes of data being transferred in each connection are numbered by TCP. These numbers start
with a _________ ( )
a) Fixed number
b) Random sequence of 0’s and 1’s
c) One
d) Sequence of zero’s and one’s

3) Which of the following is false with respect to TCP? ( )

a) Connection-oriented
b) Process-to-process
c) Transport layer protocol
d) Unreliable

4) ____________ is an attack where the attacker is able to guess together with the sequence
number of an in progress communication session & the port number. ( )
a) TCP Spoofing
b) TCP Blind Spoofing
c) IP Spoofing
d) IP Blind Spoofing

5) Packets of data that is transported by IP is called _______ ( )

a) Datagrams
b) Frames
c) Segments
d) Encapsulate message
6) ______ offers a transparent design which leaves the end-end connection of TCP intact.
7) Communication offered by TCP is ________
8) TCP issues in Mobile IP networks _____ and _____
9) In TCP, sending and receiving data is done as _______
10) To achieve reliable transport in TCP, ___________ is used to check the safe and sound
arrival of data.

Answers

1) B 2) D 3) D 4) B 5) A
6) Snooping TCP 7) Full-duplex 8) Handoff problem & High transmission error rate
9) Stream of bytes 10) Acknowledgment