Scribd
Upload
85 views

Decode Modem Setting With PLCC Configuration

The document discusses configuration settings for decoding modems using PLCC in telegraph mode. It outlines settings for the carrier frequency, power levels, and data channel configurations at both the master and remote ends, including center frequencies and filtering bands. It also notes that loopback testing was successful at 406/300 baud rates between the local and remote decode modems via hyperterminal.

Uploaded by

manish
Copyright
© © All Rights Reserved
Available Formats
Download as PDF, TXT or read online on Scribd
85 views

Decode Modem Setting With PLCC Configuration

The document discusses configuration settings for decoding modems using PLCC in telegraph mode. It outlines settings for the carrier frequency, power levels, and data channel configurations at both the master and remote ends, including center frequencies and filtering bands. It also notes that loopback testing was successful at 406/300 baud rates between the local and remote decode modems via hyperterminal.

Uploaded by

manish
Copyright
© © All Rights Reserved
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 5

Decode Modem Setting with PLCC in Telegraph Mode:

1-PLCC Configuration:
i-Master end

Carrier Frequency – Depend upon site

PLCC Power (In Watt)- Depend upon Line length


Data Channel Configuration in 4-Wire Mode at Speech Port at Master side PLCC

Centre Frequency of data in 406 Band: - 3000 Hz


Filtering band as shown in above picture: - 360 Hz

ii-Remote End
2-Data Channel Configuration in 4-Wire Mode at Speech Port

Centre Frequency of data in 406 Band: - 3000 Hz


Filtering band as shown in above picture: - 360 Hz

Decode Modem Setting at Local Side


Decode Modem Setting at Remote Side

Loopback Result by testing Hyper terminal at 406/300 Baud rate setting

Remark:
Loopback found ok at Soft & hard loop in Modem as well as PLCC also.
Hyper terminal setting

You might also like