Scribd
Upload
433 views

Bridge User Guide V1.3

Install the Ultraloq product and U-tec app. Plug the bridge into an outlet within 10 feet of the lock. Use the app to connect to the bridge and pair with the lock. The yellow LED will blink during setup. Once connected, the lock status can be checked remotely using the app and an internet connection.

Uploaded by

Jose Luis Rodriguez Escobar
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
433 views

Bridge User Guide V1.3

Install the Ultraloq product and U-tec app. Plug the bridge into an outlet within 10 feet of the lock. Use the app to connect to the bridge and pair with the lock. The yellow LED will blink during setup. Once connected, the lock status can be checked remotely using the app and an internet connection.

Uploaded by

Jose Luis Rodriguez Escobar
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 2

V1.

1. Install 2. Plug In 3. Connect 4. Use


Install Ultraloq product Plug Bridge into a power outlet Use U-tec app to pair the Ultraloq Unlock your Ultraloq and check its
and download “U-tec” app to within 10 ft (3 m) from Ultraloq. device. On the Lock Setting screen in status from anywhere with an
smartphone. Yellow LED will be steady. the App, connect to the Bridge and internet connection.
follow the instructions.
Yellow LED will blink.
FAQ
1) If two or more Bridges were plugged in,
how to identify them when connecting?
Light Status To connect to designated Bridge, please
only keep the designated Bridge plugged
and unplug other Bridges.
2) What to do if red LED appears?
Wi-Fi Bluetooth Green a. Make sure if the Wifi is 2.4GHz.
(1) Steady - Sleeping mode b. Restart the router and check Wifi
connecting well.
Yellow c. Unplug and re-plug Bridge.
3) What to do if blue LED appears?
(1) Steady - Smart-config (Factory Reset) state
a. Bridge and lock should be near each other
(2) Blinking - System boot / Configuration in progress within 10ft / 3m.
b. Press the Restart button on the lock.
Blue c. Close and re-open the App.
d. Unplug and re-plug Bridge.
(1) Steady - Data transfer with Ultraloq
Ultraloq Terms & Policies
Red Before using all Ultraloq products, please read
Internet Access Bluetooth Access (1) Steady - Cannot connect to Wi-Fi all applicable terms, rules, policies and usage
provisions found at www.u-tec.com/compa-
(2) Blinking - Connot connect to Ultraloq via Bluetooth ny/privacy. By using your Ultraloq, you agree to
be bound by the U-tec Privacy Policy.

You might also like