Scribd
Upload
218 views10 pages

Water and Waste Water Engineering: Dry Weather Flow

Dry weather flow refers to the waste water flow in sewer systems during dry periods and consists mainly of domestic sewage and industrial wastewater. The key factors that affect dry weather flow are the rate of water supply, population growth, type of area served (residential, industrial, commercial), and infiltration of groundwater. The sewers need to be designed based on these factors, with a minimum design rate of 150 litres per capita per day. Population growth over time and future developments must also be considered to accurately determine sewage quantities.

Uploaded by

SanthoshMBSanthu
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
218 views10 pages

Water and Waste Water Engineering: Dry Weather Flow

Dry weather flow refers to the waste water flow in sewer systems during dry periods and consists mainly of domestic sewage and industrial wastewater. The key factors that affect dry weather flow are the rate of water supply, population growth, type of area served (residential, industrial, commercial), and infiltration of groundwater. The sewers need to be designed based on these factors, with a minimum design rate of 150 litres per capita per day. Population growth over time and future developments must also be considered to accurately determine sewage quantities.

Uploaded by

SanthoshMBSanthu
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 10

Water And Waste Water Engineering

DRY WEATHER FLOW

Prepared by:
Ghanashyam prajapati(13cv88)
INTRODUCTION
In order to determine the section of the sewer, it is
essential to the total quantity know quantity of waste water
or sewage that would flow through the sewer.
The total waste water is devided in two parts:-
Dry weather flow
Storm weather flow
DRY WEATHER FLOW
Dry weather flow refers to the waste water flow in a sewer
system during periods of dry weather with minimum
infiltration. The consequences of the lower flow apply to
both combined sewer systems and to separate sanitary sewer
systems.
It consists mainly of
Domestic sewage
Industrial waste water
The dry weather flow is also sometimes called as “sanitary
sewage”.
FACTORS AFFECTING
DWF
The dry weather flow or the quantity of sanitary sewage
depends upon the following factors:-
 Rate of water supply
 Population growth
 Type of area served
 Infiltration of ground water
RATE OF WATER
SUPPLY
The rate of water supply to a cityltown is expressed so
many litres/capita/day.
The quantity of waste water entering the sewers would be
less than the total quantity of water supplied.
This is This is because of the fact that water is lost in
domestic consumption, evaporation, lawn sprinkling. fire
fighting, industrial consumption. However, private source
of water supply(i e. water from domestic wells etc.) and
infiltration of sub-soil water in the sewers increase the waste
water flow rate.
CONT.
This extra water that enters the sewers can be assumed to
approximately equal to the water lost in consumption etc.
Due to this reason, the waste water flow rate may be
assumed equal to the rate of water supply by the municipal
authorities. The sewers should be designed for a minimum
of 150 litres per capita per day.
POPULATION GROWTH
The quantity of sanitary sewage directly depends on the
population.
As the population increases the quantity of sanitary sewage
also increases.
The quantity of water supply is equal to the rate of supply
multiplied of population.
The sewage quantity which will be produced in the town
due to future developments of the town and population
should be taken into account and as far as possible accurate
results should be obtained.
TYPE OF AREA SERVED
The quantity of sanitary sewage also depends on the type
of area to be served, whether it is residential, industrial or
commercial.
The quantity of sewage produced in residential areas
directly depends on the quantity of water supply to the area.
The quantity is obtained by multiplying the population with
this factor.
The quantity of sewage produced by various industries
depends on their various industrial, processes, and it is
different for each industry. This quantity can be determined
by doing a survey of that area and collecting the data.
INFILTRATION OF
GROUND WATER
Ground water or sub-soil water may infiltrate into the
sewers through the leaky joints.
Exfiltration is the reverse process which indicated the flow
of waste water from the sewer into the ground.
While due to infiltration the quantity of flow through sewer
increases, exfiltration results in decrease in the flow and
consequent increase in the pollution of ground water.
Both infiltration as well as exfiltration are undesirable and
take place due to imperfect joints. Infiltration unnecessarily
increases the load on the treatment works.

You might also like