Scribd
Upload
50 views

Ansys Chapter 06

This chapter discusses surface modeling techniques. Section 6.1 describes using the Revolve function to model bellows joints and examines the radial deformation and hoop stress under internal pressure. Section 6.2 discusses using the Mid-Surface function to create beam brackets. Section 6.3 presents a gearbox problem, specifying the materials used for components, and techniques like Thin/Surface bodies, bearing loads, and bonded connections.

Uploaded by

Tran Van Tien
Copyright
© © All Rights Reserved
Available Formats
Download as DOC, PDF, TXT or read online on Scribd
50 views

Ansys Chapter 06

This chapter discusses surface modeling techniques. Section 6.1 describes using the Revolve function to model bellows joints and examines the radial deformation and hoop stress under internal pressure. Section 6.2 discusses using the Mid-Surface function to create beam brackets. Section 6.3 presents a gearbox problem, specifying the materials used for components, and techniques like Thin/Surface bodies, bearing loads, and bonded connections.

Uploaded by

Tran Van Tien
Copyright
© © All Rights Reserved
Available Formats
Download as DOC, PDF, TXT or read online on Scribd
You are on page 1/ 8

Chapter 6 Surface Models 1

Chapter 6
Surface Models
6.1 Step-by-Step: Bellows Joints
6.2 Step-by-Step: Beam Bracket
6.3 More Exercise: Gearbox
6.4 Review
Chapter 6 Surface Models Section 6.1 Bellows Joints 2

Section 6.1
Bellows Joints

Problem Description

With the internal pressure, the


engineers are concerned about
the radial deformation (due to
an engineering tolerance
consideration) and hoop stress
(due to a safety consideration).
Chapter 6 Surface Models Section 6.1 Bellows Joints 3

R315 R315 28

20
Unit: mm.

28
Chapter 6 Surface Models Section 6.1 Bellows Joints 4

Techniques/Concepts

Create surface bodies


using <Revolve>.
Top/Bottom of a
surface body
Shell Elements
Chapter 6 Surface Models Section 6.2 Beam Bracket 5

Section 6.2
Beam Bracket

Techniques/Concept
s

Create surface bodies


using <Mid-Surface>
Chapter 6 Surface Models Section 6.3 Gearbox 6

Section 6.3
Gearbox

Problem Description
[3] The
housing is
made of
[1] The stainless
flanged sheet steel of
bearing is 3 mm
made of gray thickness.
cast iron.

[2] The base is


also made of
cast iron.
Chapter 6 Surface Models Section 6.3 Gearbox 7

100
170 200 70

(R170) Unit: mm.


30

(R70)
355

R30 R20
170

R50 R40
15

520 180

540 240
Chapter 6 Surface Models Section 6.3 Gearbox 8

Techniques/Concept
s

Create surface bodies


by <Thin/Surface>
Loads>Bearing Loads
Set up <Bonded>
connections.

You might also like