Scribd
Upload
51 views

BA Pen Kit - (Baron II Pen Kit) : Turning Diameters

The document provides instructions for assembling a Baron II pen kit, including the required drill bits of 25/64" and 15/32", bushings code A0009, turning the pen blank diameters to 13.6mm for the short tube and 12.3mm for the long tube, and a 4 step assembly process of pressing the writing nib coupler, end cap, clip assembly, and center band onto the tubes.

Uploaded by

Daniel Modica
Copyright
© © All Rights Reserved
Available Formats
Download as PDF, TXT or read online on Scribd
51 views

BA Pen Kit - (Baron II Pen Kit) : Turning Diameters

The document provides instructions for assembling a Baron II pen kit, including the required drill bits of 25/64" and 15/32", bushings code A0009, turning the pen blank diameters to 13.6mm for the short tube and 12.3mm for the long tube, and a 4 step assembly process of pressing the writing nib coupler, end cap, clip assembly, and center band onto the tubes.

Uploaded by

Daniel Modica
Copyright
© © All Rights Reserved
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 1

BA Pen Kit – (Baron II Pen Kit)

Drill Bit required – 25/64" (or 10mm) & 15/32" (11.9mm)

Bushings required – Bushings – BA & SD (Code: A0009)

Turning Diameters

Turn outside diameter of the pen blank down to 13.6mm for the short tube, and 12.3mm for
the long tube.

Assembly

Layout the parts as shown below.

1. Press the Writing nib coupler onto the long tube.

2. Press the End Cap onto the other end.

3. Press the clip assembly onto the short tube.

4. Press the centre band onto the other end.

www.timberbits.com 1800 388 833 Turning a BA Pen

You might also like