Scribd
Upload
153 views

Classical Mechanics III (8.09) Fall 2014 Assignment 4: Announcements

This document is the assignment sheet for Problem Set 4 in the course Classical Mechanics III at MIT. It provides instructions for 4 problems related to rigid bodies and oscillations. Problem 1 involves calculating the torque and angular velocities of a heavy symmetric top. Problem 2 examines the normal mode frequencies of 3 masses on a circle with an exponential potential. Problem 3 analyzes small oscillations of a double pendulum using a normal mode approximation. Problem 4 concerns small amplitude oscillations of a rigid bar suspended by 2 springs.

Uploaded by

Deepneel Kundu
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
153 views

Classical Mechanics III (8.09) Fall 2014 Assignment 4: Announcements

This document is the assignment sheet for Problem Set 4 in the course Classical Mechanics III at MIT. It provides instructions for 4 problems related to rigid bodies and oscillations. Problem 1 involves calculating the torque and angular velocities of a heavy symmetric top. Problem 2 examines the normal mode frequencies of 3 masses on a circle with an exponential potential. Problem 3 analyzes small oscillations of a double pendulum using a normal mode approximation. Problem 4 concerns small amplitude oscillations of a rigid bar suspended by 2 springs.

Uploaded by

Deepneel Kundu
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 4

Classical Mechanics III (8.

09) Fall 2014


Assignment 4
Massachusetts Institute of Technology
Physics Department Due October 6, 2014
September 29, 2014 6:00pm

Announcements
This week we finish our discussion of Rigid Bodies. We will then briefly discuss Oscillations,
and at the end of the week will begin our discussion of Canonical Transformations.

Reading Assignment for this week


• The reading for Oscillations is Goldstein Ch.6 sections 6.1-6.4.

• We will spend a few weeks on our next subject: Canonical Transformations, the
Hamilton-Jacobi equations, and Action-Angle Variables. The complete reading for
this material is Goldstein Ch.9 sections 9.1-9.7, and then Ch.10 sections 10.1-10.6,
and 10.8.

1
Physics 8.09, Classical Physics III, Fall 2014 2

Problem Set 4
In the first problem we look at a symmetric top, and in the final three problems we
study oscillations.

1. A Heavy Symmetric Top [10 points]


A heavy symmetric top (I1 = I2 ) with one point fixed is precessing at a steady angular
velocity Ω about the vertical fixed inertial axis zI . The Euler angle coordinates are
defined as in lecture (and Goldstein), and here θ̇ = 0. The top’s mass is m and its
center of mass is a distance R from the fixed point. Define ω i ≡ ψ̇.

(a) [3 points] Determine the components of the torque in terms of Euler angles.
(b) [2 points] Write the angular velocities in terms of Euler angles. Explain why ω i
is constant in time.
(c) [5 points] Derive a minimum condition for ω i . Describe what type of tops will
satisfy this condition for all possible ω i s.

2. Three Point Masses on a Circle [16 points]

Three particles of equal mass m move on a circle with radius a under forces that can
be derived from the potential

V (α, β, γ) = V0 e−2α + e−2β + e−2γ .


� �

Here α, β, and γ are the angular separations of the masses in radians as shown
in the figure. An equilibrium position is indicated by the dashed lines and has
α = β = γ = 2π/3.
(a) [6 points] Find the normal mode frequencies using
the small amplitude approximation for oscillations
about equilibrium. Determine the corresponding
normalized normal modes.
α (b) [3 points] What are the corresponding normal co­
m θ1
m
ordinates and equations of motion for the normal
θ2 coordinates?
γ (c) [3 points] Sketch the corresponding motion for each
β θ3 normal mode.
(d) [4 points] Consider the following initial conditions
m at t = 0: θ1 = θ2 = θ3 = 0, θ˙1 = 3ω0 , θ˙2 = −2ω0 ,
and θ˙3 = −ω0 . Use your results above to find θi (t)
for i = 1, 2, 3.
Physics 8.09, Classical Physics III, Fall 2014 3

3. Small Oscillations of the Double Pendulum [14 points]


Consider the double pendulum in a plane that you analyzed on problem set #1. Use
results from that problem as a starting point for this one. Take m2 = m and m1 = 3m.
a) [4 points] Make a small angle approximation for θ1
and θ2 , and determine results for the kinetic and poten­
θ1
tial energies which are quadratic in θ˙i and θi .
ι1
b) [4 points] What are the normal mode frequencies of
this system? Confirm that the eigenvalues are positive
m1
and frequencies are real.
ι2 θ2

m2 c) [6 points] Compute the corresponding eigenvectors


and hence determine the normal modes. Sketch the cor­
responding motion of the pendulum for each one.
Image by MIT OpenCourseWare.

4. A Rigid Oscillating Bar [20 points] (Adapted from Goldstein Ch.6 #11)
Consider a thin uniform rigid bar of length L=2£ and mass m suspended by two equal
springs with force constant k. In this problem we will consider the small oscillation
modes of the bar in the plane. When the bar is at rest at equilibrium we have
θ1 = θ2 = θ0 and φ = 0, and the length of the springs is a. At a given instant the bar
has rotated about its center from a horizontal position by the angle denoted by φ.
(a) [7 points] What is the equilibrium
length of the springs without the
bar attached in terms of the given
k k parameters? What are a suitable
θ1 θ2 set of coordinates for describing
the motion of the bar in the plane?
Using these coordinates determine
L φ the Lagrangian L = T − V (with­
out making a small amplitude ap­
proximation).
Image by MIT OpenCourseWare.

(b) [5 points] Determine a suitable form for T and V to study small amplitude
oscillations. Write your answer in terms of matrices that depend only on k, m,
g, a, £, and θ0 . For simplicity, to answer this problem and the problem below,
assume θ0 is small and only work to linear order in θ0 .
(c) [8 points] What are the normal modes of small oscillation? Make a sketch of
each of these oscillations. What would differ if θ0 = 0?
MIT OpenCourseWare
http://ocw.mit.edu

8.09 Classical Mechanics III


Fall 2014

For information about citing these materials or our Terms of Use, visit: http://ocw.mit.edu/terms.

You might also like