Scribd
Upload
67 views

Kathmandu Engineering College Kalimati, Kathmandu 2075

This document is a 10 question multiple choice exam for a workshop technology course at Kathmandu Engineering College. The exam covers topics related to tools, machines, welding processes, and material properties. It tests knowledge of marking and measuring tools, machine tools, lathe operations, welding gas percentages, threading tools, precision measuring tools, turning operations, sheet metal operations, Hooke's law, and material hardness.

Uploaded by

विशाल पुडासैनी
Copyright
© © All Rights Reserved
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
67 views

Kathmandu Engineering College Kalimati, Kathmandu 2075

This document is a 10 question multiple choice exam for a workshop technology course at Kathmandu Engineering College. The exam covers topics related to tools, machines, welding processes, and material properties. It tests knowledge of marking and measuring tools, machine tools, lathe operations, welding gas percentages, threading tools, precision measuring tools, turning operations, sheet metal operations, Hooke's law, and material hardness.

Uploaded by

विशाल पुडासैनी
Copyright
© © All Rights Reserved
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
You are on page 1/ 2

KATHMANDU ENGINEERING COLLEGE Exam Final Assessment

KALIMATI, KATHMANDU Level B. E. Full Marks 10


2075 Program BCT Pass Marks 4
Year/Part I/I Time 5 min
SET B
Workshop Technology

Name: Roll No:

 Attempt all questions

 Put tick (√ ) mark choosing the best answer.

1. Which of the following is a marking tool?


a. Scriber c. Divider
b. Try-square d. All of the above

2. Which of these is not a machine tool?


a. lathe c. Drilling
b. shaper d. Vice

3. In lathe machine
a. job is stationary and tool rotate c. both job and tool rotate
b. tool is stationary and job rotate d. both a and b

4. During oxy-acetylene gas welding, oxidizing flame is produced when the percentage of
oxygen is
a. 75% b. 50%
b. 25% c. 20%

5. The tool used to make the threads inside a cylindrical shaft is called
a. Reamer c. Tap
b. Die d. None of the above

6. Which of these measuring tools has high precision?


a. Steel Rule c. Protractors
b. Divider d. Vernier Caliper

7. The process of reducing diameter of the work piece in lathe operations is called
a. Facing c. Turning
b. Spinning d. Rolling

8. Which of these is not sheet metal operation


a. Shearing c. Notching
b. Slitting d. None of the above
9. Hooke’s law is obeyed by every material
a. Within plastic limit
b. Within yield point
c. Up to limit of proportionality
d. None of the above

10. The ability of material to resist the scratching, abrasion, indentation or penetration is
called
a. Hardness
b. Rigidity
c. Toughness
d. None of the above

You might also like