Iecex Certificate of Conformity
Iecex Certificate of Conformity
of Conformity
INTERNATIONAL ELECTROTECHNICAL COMMISSION
IEC Certification Scheme for Explosive Atmospheres
for rules and details of the IECEx Scheme visit www.iecex.com
UNIT VERIFICATION
Type of Protection: nA
Signature:
(for printed version)
Date:
This Unit verification certificate is issued as verification that the Apparatus identified on page 1, was assessed and tested and found to comply
with the IEC Standard list below. This certificate is granted subject to the conditions as set out in IECEx Scheme Rules, IECEx 02 and
Operational Documents as amended.
STANDARDS:
The electrical apparatus and any acceptable variations to it specified in the schedule of this certificate and the identified documents, was found
to comply with the following standards:
IEC 60079-0 : 2004 Electrical apparatus for explosive gas atmospheres - Part 0: General requirements
Edition:4.0
IEC 60079-15 : 2005-03 Electrical apparatus for explosive gas atmospheres Part 15: Construction, test and Marking of Type of
Edition:3 Protection "n" electrical apparatus
This Certificate does not indicate compliance with electrical safety and performance requirements other than those expressly included in the
Test Report:
NL/DEK/ExTR11.0118/00 NL/DEK/ExTR12.0031/00
NL/DEK/QAR11.0042/00
IECEx Certificate
of Conformity
Certificate No: IECEx DEK 11.0102X Issue No: 0
Schedule
EQUIPMENT:
Equipment and systems covered by this certificate are as follows:
Description
The generator of Type DG185ZL-04 of the design nos. 2082150ZL9 and 2082250ZL1 are non-sparking 3 phase, 4 pole, synchronous
generator with brushless exciter and closed, water cooled, air ventilation circuit.
The synchronous generator is in type of protection nA, the auxiliary equipment in types of protection Ex d, e, mb, (nL), op is and
additionally nC when equipped with partial discharge monitor and air gap flux probe.
Electrical data
Rated voltage: 11 kV
Rated Output: 30 MVA at power factor 0.80
Frequency: 50 Hz
Speed: 1 500 rpm
The secondary circuit of the current transformers must be closed at all time.