DOOSAN INFRACORE INDUSTRIAL ENGINE

D34
Intermittent rating Max. torque Aftertreatmnet
kW(HP) / rpm N.m(kg.m) / rpm System
54 (74) / 2400 330 (33.7) / 1400 DOC
63 (85) / 2400 325 (33.1) / 1600
69 (92) / 2400 350 (35.7) / 1600
75 (100) / 2400 375 (38.2) / 1600 DOC + SCR
82 (110) / 2400 430 (43.8) / 1400
97 (130) / 2400 500 (51.0) / 1400

◎ MECHANICAL SYSTEM ◎ FUEL SYSTEM

o Engine Model D34 o Injection pump DELPHI DFP 4.2
o Engine Type In-line 4 cycle Diesel, o Governor Controlled by ECU
water cooled, Turbo-intercooler o Feed pump N/A
o Combustion type Direct injection o Injection nozzle Multi hole type
o Cylinder Type Linerless o Fuel filter Full flow, cartridge type
o Number of cylinders 4 o Used fuel EN590
o Bore x stroke 98 x 113 mm
o Displacement 3.409 lit. ◎ LUBRICATION SYSTEM
o Compression ratio 17.0 : 1 o Lub. Method Fully forced pressure feed type
o Firing order 1-3-4-2 o Oil pump Gear type driven by crankshaft
o Dry weight 335 kg o Oil filter Full flow, cartridge type
(w/o starter, alternator, aftertreatment) o Oil pan capacity High level 12.6 liters(except 130HP)
o Dimension (LxWxH) Low level 6.0 liters(except 130HP)
889.6x655.2x804.5mm(with DOC) High level 14.3 liters(130HP)
875x655.2x804.5mm(with DOC/Fan Height 475mm) Low level 6.4 liters(130HP)
896.9x655.2x992mm(with DOC+SCR/ up to 110HP) o Angularity limit 35 deg all around
896.9x695.9x1005.4mm(with DOC+SCR/over 110HP) o Lub. Oil 10W30 CJ-4
o Rotation Counter clockwise viewed from Flywheel (Refer to Operation Manual)
o Fly wheel housing SAE NO.3M(SAE J617) o Maximum oil temp 135℃ at main oil gallery
o Fly wheel Clutch 11 1/2"(SAE J620) o Lub oil pressure Idle Speed : Min 100 kPa
o Number of teeth 125
(Flywheel) ◎ COOLING SYSTEM
◎ ENGINEERING DATA o Cooling method Fresh water forced circulation
o Water flow 114 liters/min @2,400 rpm (100HP) o Water capacity Approx. 5.1 lit
o Heat rejection (engine only)
-.to coolant 12.0 kcal/sec @2,400 rpm (74HP) o Water pump Centrifugal type driven by belt
-.to coolant 14.2 kcal/sec @2,400 rpm (100HP) o Thermostat Wax – pellet type
-.to coolant 14.9 kcal/sec @2,400 rpm (110HP) Opening temp. 82°C
-.to coolant 16.2 kcal/sec @2,400 rpm (130HP) Full open temp. 97°C
-.to CAC 2.2 kcal/sec @2,400 rpm (74HP) o Cooling fan Not Available
-.to CAC 2.6 kcal/sec @2,400 rpm (100HP) o Water Temperature 110℃ (max.)
-.to CAC 2.8 kcal/sec @2,400 rpm (110HP)
-.to CAC 3.6 kcal/sec @2,400 rpm (130HP) ◎ ELECTRICAL SYSTEM
o Air flow 5,280 liter/min @2,400 rpm (100HP) o Battery Charging 12V x 90A
o Exhaust gas temp. 750 °C↓ @2,400 rpm Alternator
o Max. permissible restrictions o Voltage regulator Built-in type IC regulator
-.Intake system 2.16 kPa clean filter o Starting motor 12V x 2.7kW
6.23 kPa dirty filter o Battery Voltage 12V
 -.Exhaust system 20 kPa max.(DOC only version) o Battery Capacity 100 Ah, 950CCA ↑(recommended)
30 kPa max.(DOC+SCR version) o Starting Aid Air heater
◎ VALVE SYSTEM
o Type Over head valve
o Number of valve Intake 2, exhaust 2 per cylinder
o Valve lashes Intake 0.4mm
(@ cold) Exhaust 0.45mm

54KW(74HP) 63KW(85HP)
[Nm] Torque [Nm] Power [kW] [kW] [Nm] Torque [Nm] Power [kW] [kW]
350.0 200.0 350.0 200.0
180.0 180.0
300.0 300.0
160.0 160.0
250.0 140.0 250.0 140.0
200.0 120.0 200.0 120.0
100.0 100.0
150.0 80.0 150.0 80.0
100.0 60.0 100.0 60.0
40.0 40.0
50.0 50.0
20.0 20.0
0.0 0.0 0.0 0.0
600 800 1000 1200 1400 1600 1800 2000 2200 2400 2600 2800 600 800 1000 1200 1400 1600 1800 2000 2200 2400 2600 2800
[rpm] [rpm]

69KW(92HP) 75KW(100HP)
[Nm] Torque [Nm] Power [kW] [kW] [Nm] Torque [Nm] Power [kW] [kW]
400.0 200.0 400.0 200.0
350.0 180.0 350.0 180.0
160.0 160.0
300.0 300.0
140.0 140.0
250.0 120.0 250.0 120.0
200.0 100.0 200.0 100.0
150.0 80.0 150.0 80.0
60.0 60.0
100.0 100.0
40.0 40.0
50.0 20.0 50.0 20.0
0.0 0.0 0.0 0.0
600 800 1000 1200 1400 1600 1800 2000 2200 2400 2600 2800 600 800 1000 1200 1400 1600 1800 2000 2200 2400 2600 2800
[rpm] [rpm]
82KW(110HP) 97KW(130HP)
[Nm] Torque [Nm] Power [kW] [kW] [Nm] Torque[Nm] Power[kW] [kW]
500.0 200.0 600.0 200.0
450.0 180.0 180.0
400.0 160.0 500.0 160.0
350.0 140.0 400.0 140.0
300.0 120.0 120.0
250.0 100.0 300.0 100.0
200.0 80.0 80.0
150.0 60.0 200.0 60.0
100.0 40.0 100.0 40.0
50.0 20.0 20.0
0.0 0.0 0.0 0.0
600 800 1000 1200 1400 1600 1800 2000 2200 2400 2600 2800 600 800 1000 1200 1400 1600 1800 2000 2200 2400 2600 2800
[rpm] [rpm]

o Dimension (LxWxH)
-D34_74HP_DOC only 889.6x655.2x804.5mm(with DOC)

-D34_74HP_DOC only (Fan Heigh option_475mm) 875x655.2x804.5mm(with DOC/Fan Height 475mm)

-D34_Up to 110HP_DOC+SCR 896.9x655.2x992mm(with DOC+SCR/ up to 110HP)

-D34_Over 110HP_DOC+SCR 896.9x695.9x1005.4mm(with DOC+SCR/over 110HP)

◆ CONVERSION TABLE
in. = mm x 0.0394 lb/ft = N.m x 0.737
PS = kW x 1.3596 U.S. gal = lit. x 0.264
psi = kg/cm2 x 14.2233
kW = 0.2388 kcal/s
in3 = lit. x 61.02 lb/PS.h = g/kW.h x 0.00162
hp = PS x 0.98635 cfm = m3/min x 35.336
lb = kg x 2.20462

Revised : 30th, June, 2016

※ Speccifications are subject to change without prior notice