COMP 6204 VOIP:

Cisco CME Report

(Router based SCCP)
. . . . . . . . . .

Installation and configuration report

with physical Cisco Phones, the Issues,
Problems and Troubleshooting and
Final Result

Written By Nathan Fitness 27026688

 Table of Contents:

Introduction.............................................................................................3

Installation............................................................................................... 4

Operating System Patching....................................................................6

Cisco Phone firmware.............................................................................7

Cisco Phone Configuring...........................................................................7

. . . . . . . . . .
Introduction

This report is going to document what I have done in attempting top get Taridium ipbx
eXpress installed and configured to work with Cisco phones loaded with sip firmware.

There are putty log files included as well as screenshots

The hardware used is as follows:

Router:

Serial number: FHK1341F3RP

PID / VID CISCO2821 V05
Mac address #1:
Mac address #2:

Switch:

Serial number: CAT1049ZHNH

Mac address: 001A6DB18880
PID / VID S-C3560-48PS-S V04

Phones: used (tried)

IP Phone 7941
Serial number: FCH120797Z0
Mac address: 001F6C802164
PID / VID CP-7941GV02

IP Phone 7941
Serial number: FCH12098FEY
Mac address: 01F9E2525CF
PID / VID CP-7941GV02

IP Phone 7911
Serial number: FCH141192ZJ
Mac address: 081FF3624FC1
PID / VID CP-7911GV08

3
Installation

Installation is via CLI

Configuring CME

Configuring was fairly straight forward except for a few parts

The first part was where the DHCP server installable from the web GUI did not work, so one
had to be manually installed, the problem with this was once installed it has to be started
manually via the CLI.

Second the TFTP service was not reliable. This meant the phones would fail to find their
configuration files, yet alone any of their firmware files.

And third, the configuration files created by the ipbx GUI did not work for any of my phones,
forcing me to create a template using Cisco’s xml layout.

Cisco Phone firmware

First part was copying the phones flash firmware to the routers flash: storage

This was done using the routers “copy tftp://10.0.10.11/ flash:” command

 SCCP41.9-4-2SR3-1S loaded on phones (7941)

Cisco Phone Configuring

Next we had to configure the phones configuration template.

Success… Phones Work Rung 1001 from 1002, seems to have dialing delay

3
Switches final dial peer startup configuration file

Switch#sh run
Building configuration...

Current configuration : 5379 bytes

!
version 12.2
no service pad
service timestamps debug datetime msec
service timestamps log datetime msec
no service password-encryption
!
hostname Switch
!
boot-start-marker
boot-end-marker
!
!
!
!
no aaa new-model
system mtu routing 1500
!
!
!
!
crypto pki trustpoint TP-self-signed-1840351360
enrollment selfsigned
subject-name cn=IOS-Self-Signed-Certificate-1840351360
revocation-check none
rsakeypair TP-self-signed-1840351360
!
!
crypto pki certificate chain TP-self-signed-1840351360
certificate self-signed 01
3082023F 308201A8 A0030201 02020101 300D0609 2A864886 F70D0101 04050030
31312F30 2D060355 04031326 494F532D 53656C66 2D536967 6E65642D 43657274
69666963 6174652D 31383430 33353133 3630301E 170D3933 30333031 30303031
31305A17 0D323030 31303130 30303030 305A3031 312F302D 06035504 03132649
4F532D53 656C662D 5369676E 65642D43 65727469 66696361 74652D31 38343033
35313336 3030819F 300D0609 2A864886 F70D0101 01050003 818D0030 81890281
8100ACFE DBBF822E 1E18C10E 2D3FBD45 8957E987 DE856972 4D94C929 8D4E54B5
928118F7 D708931E 037E7C20 C1E806A4 45DD3545 8B099AC1 5989C7AC 669C03FD
73BFD348 B54C8951 64568302 C457FF39 73D91334 48127CC5 07A58EF2 A88F35A7
947720C9 CBD5EE93 53EAD8BB FC733C38 12CF0612 12AA4303 DD112A5E BB11EA28
CEE70203 010001A3 67306530 0F060355 1D130101 FF040530 030101FF 30120603
551D1104 0B300982 07537769 7463682E 301F0603 551D2304 18301680 145E9CFA
6A12291C 1DFCADF7 7AEF1C9F 9BAC19DE 58301D06 03551D0E 04160414 5E9CFA6A
12291C1D FCADF77A EF1C9F9B AC19DE58 300D0609 2A864886 F70D0101 04050003
81810015 DC0D5A31 26860444 49CE8508 A8605877 2CCE0EAE 349B6E4B 58F1A7E3
1475E82D F2BC367B ED662D98 FD9B5794 63157F88 12B7F94F A533E873 33D9D585
A975CD8D 51B075BE CC6A20D9 7182A76F 61881682 85BE38B6 01C7F611 B98B65CA
97C59D01 A81D9FF4 2CAF2E04 BA33BAA0 1CA6849B E6B6A3D8 1C9E9600 8476B820
54B691
quit

3
!
!
!
spanning-tree mode pvst
spanning-tree extend system-id
!
vlan internal allocation policy ascending
!
!
!
!
interface FastEthernet0/1
switchport access vlan 10
switchport mode access
switchport voice vlan 50
spanning-tree portfast
!
interface FastEthernet0/2
switchport access vlan 10
switchport mode access
switchport voice vlan 50
spanning-tree portfast
!
interface FastEthernet0/3
switchport access vlan 10
switchport mode access
switchport voice vlan 50
spanning-tree portfast
!
interface FastEthernet0/4
switchport access vlan 10
switchport mode access
switchport voice vlan 50
spanning-tree portfast
!
interface FastEthernet0/5
switchport access vlan 10
switchport mode access
switchport voice vlan 50
spanning-tree portfast
!
interface FastEthernet0/6
switchport access vlan 10
switchport mode access
switchport voice vlan 50
spanning-tree portfast
!
interface FastEthernet0/7
switchport access vlan 10
switchport mode access
switchport voice vlan 50
spanning-tree portfast
!
interface FastEthernet0/8
switchport access vlan 10
switchport mode access

3
 switchport voice vlan 50
spanning-tree portfast
!
interface FastEthernet0/9
switchport access vlan 10
switchport mode access
switchport voice vlan 50
spanning-tree portfast
!
interface FastEthernet0/10
switchport access vlan 10
switchport mode access
switchport voice vlan 50
spanning-tree portfast
!
interface FastEthernet0/11
switchport access vlan 10
switchport mode access
switchport voice vlan 50
spanning-tree portfast
!
interface FastEthernet0/12
switchport access vlan 10
switchport mode access
switchport voice vlan 50
spanning-tree portfast
!
interface FastEthernet0/13
switchport access vlan 10
switchport mode access
switchport voice vlan 50
spanning-tree portfast
!
interface FastEthernet0/14
switchport access vlan 10
switchport mode access
switchport voice vlan 50
spanning-tree portfast
!
interface FastEthernet0/15
switchport access vlan 10
switchport mode access
switchport voice vlan 50
spanning-tree portfast
!
interface FastEthernet0/16
switchport trunk encapsulation dot1q
switchport mode trunk
spanning-tree portfast
!
interface FastEthernet0/17
!
interface FastEthernet0/18
!
interface FastEthernet0/19
!

3
interface FastEthernet0/20
!
interface FastEthernet0/21
!
interface FastEthernet0/22
!
interface FastEthernet0/23
!
interface FastEthernet0/24
!
interface FastEthernet0/25
!
interface FastEthernet0/26
!
interface FastEthernet0/27
!
interface FastEthernet0/28
!
interface FastEthernet0/29
!
interface FastEthernet0/30
!
interface FastEthernet0/31
!
interface FastEthernet0/32
!
interface FastEthernet0/33
!
interface FastEthernet0/34
!
interface FastEthernet0/35
!
interface FastEthernet0/36
!
interface FastEthernet0/37
!
interface FastEthernet0/38
!
interface FastEthernet0/39
!
interface FastEthernet0/40
!
interface FastEthernet0/41
!
interface FastEthernet0/42
!
interface FastEthernet0/43
!
interface FastEthernet0/44
!
interface FastEthernet0/45
!
interface FastEthernet0/46
!
interface FastEthernet0/47
!

3
interface FastEthernet0/48
!
interface GigabitEthernet0/1
!
interface GigabitEthernet0/2
!
interface GigabitEthernet0/3
!
interface GigabitEthernet0/4
!
interface Vlan1
ip address dhcp
!
interface Vlan10
ip address 10.0.10.29 255.255.255.0
!
interface Vlan99
no ip address
!
ip default-gateway 10.0.10.1
ip classless
ip http server
ip http secure-server
!
!
!
!
!
line con 0
line vty 0 4
login
line vty 5 15
login
!
end

Switch#

3
Router’s final dial peer startup configuration file

Router#sh run
Building configuration...

Current configuration : 2882 bytes

!
! Last configuration change at 05:30:46 UTC Thu Oct 11 2018
!
version 15.0
service timestamps debug datetime msec
service timestamps log datetime msec
no service password-encryption
!
hostname Router
!
boot-start-marker
boot-end-marker
!
! card type command needed for slot/vwic-slot 0/0
!
no aaa new-model
!
!
!
!
!
!
dot11 syslog
ip source-route
!
!
ip cef
ip dhcp excluded-address 10.0.10.1 10.0.10.10
ip dhcp excluded-address 10.0.50.1 10.0.50.10
!
ip dhcp pool phone
default-router 10.0.50.1
option 150 ip 10.0.50.1
option 66 ip 10.0.50.1
!
ip dhcp pool data
default-router 10.0.10.1
option 150 ip 10.0.10.1
!
!
no ip domain lookup
no ipv6 cef
!
multilink bundle-name authenticated
!
!
!
!
!
!

3
!
!
!
!
voice-card 0
!
!
!
license udi pid CISCO2821 sn FHK1341F3RP
archive
log config
hidekeys
!
redundancy
!
!
!
!
!
!
!
!
!
!
interface GigabitEthernet0/0
no ip address
duplex auto
speed auto
!
!
interface GigabitEthernet0/0.10
encapsulation dot1Q 10
ip address 10.0.10.1 255.255.255.0
!
interface GigabitEthernet0/0.50
encapsulation dot1Q 50
ip address 10.0.50.1 255.255.255.0
!
interface GigabitEthernet0/1
ip address 192.168.100.1 255.255.255.252
duplex auto
speed auto
!
!
ip forward-protocol nd
no ip http server
no ip http secure-server
!
!
!
!
!
!
!
!
tftp-server flash:apps41.9-4-2ES26.sbn
tftp-server flash:cnu41.9-4-2ES26.sbn

3
tftp-server flash:cvm41sccp.9-4-2ES26.sbn
tftp-server flash:dsp41.9-4-2ES26.sbn
tftp-server flash:jar41sccp.9-4-2ES26.sbn
tftp-server flash:SCCP41.9-4-2SR3-1S.loads
tftp-server flash:term41.default.loads
tftp-server flash:term61.default.loads
!
control-plane
!
!
!
!
!
!
dial-peer voice 1 voip
destination-pattern 000.
session target ipv4:192.168.100.2
!
!
!
!
telephony-service
max-ephones 5
max-dn 5
ip source-address 10.0.50.1 port 2000
auto assign 4 to 6
auto assign 1 to 5
max-conferences 8 gain -6
transfer-system full-consult
create cnf-files version-stamp Jan 01 2002 00:00:00
!
!
ephone-dn 1
number 0001
!
!
ephone-dn 2
number 0002
!
!
ephone-dn 3
number 0003
!
!
ephone-dn 4
number 0004
!
!
ephone 1
device-security-mode none
!
!
!
ephone 2
device-security-mode none
!
!

3
!
ephone 3
device-security-mode none
!
!
!
ephone 4
device-security-mode none
!
!
!
line con 0
line aux 0
line vty 0 4
login
!
scheduler allocate 20000 1000
end

Router#