Scribd
Upload
109 views

Boss OD-1 Replica Instructions: Based On The ITS8 PCB

Uploaded by

Николай Прокопенко
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
109 views

Boss OD-1 Replica Instructions: Based On The ITS8 PCB

Uploaded by

Николай Прокопенко
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 3

Boss OD-1 Replica Instructions

(Based on the ITS8 PCB)


Version 2018May07 Copyright 2018 JD Sleep
Permission refused for posting/serving this file from any site other than www.generalguitargadgets.com
Copyrights mentioned here belong to their owners and not General Guitar Gadgets

This is the Boss OD-1 Overdrive Replica. Use the project documents provided,
starting with the General Build Instructions. This uses the PCB originally designed
for the Ibanez TS-808 replica. Te circuit is similar, so it works well here. There is
one resistor (R8) that needs to be installed “kitty cornered”, so pay close attention to
the parts placement diagram. There are also two wire jumpers that need to be
installed across some of the wiring pads as shown in the parts placement/wiring
diagram.

D5 is optional, it is there to prevent reverse polarity power from destroying the IC. If
you decide not to install D5, do not put a jumper in place of D5, just leave it blank.
C12 is a power supply filter cap and is also somewhat optional. If you plan on only
using battery power, you probably don't need C12. Again, if you don't install C12, do
not install a jumper, leave it blank. If you have D5 installed and you do ever zap the
unit with reverse power, hopefully all you have to do to fix it is replace or remove D5.

Page 1 of 3
Boss OD-1 Replica Instructions
(Based on the ITS8 PCB)
Version 2018May07 Copyright 2018 JD Sleep
Permission refused for posting/serving this file from any site other than www.generalguitargadgets.com
Copyrights mentioned here belong to their owners and not General Guitar Gadgets

Here's an inside view of the unit we built to show our construction details.

Here is a chart of voltages taken at the IC and transistor pins. This information can
be used to help you find and fix problems if your OD-1 Replica doesn't work when
you test it. The voltages are approximate, you may not get these exact readings, but
they should be somewhere close.

Component Location Voltage


9 volt power supply 9.4v
IC IC Pin 1 4.7v
IC Pin 2 4.8v

Page 2 of 3
Boss OD-1 Replica Instructions
(Based on the ITS8 PCB)
Version 2018May07 Copyright 2018 JD Sleep
Permission refused for posting/serving this file from any site other than www.generalguitargadgets.com
Copyrights mentioned here belong to their owners and not General Guitar Gadgets

IC Pin 3 4.7v
IC Pin 4 0v
IC Pin 5 4.7v
IC Pin 6 4.7v
IC Pin 7 4.7v
IC Pin 8 9.4v
Q1 Collector 9.4v
Base 4.2v
Emitter 3.9v
Q2 Collector 9.4v
Base 4.2v
Emitter 3.9v

Comments and questions are welcome and can be sent to


[email protected]

Page 3 of 3

You might also like