Scribd
Upload
21 views2 pages

Title: Bending Test: Materials Length Width Thickness Deflection of Beam (MM)

This document reports the results of a bending test experiment where three materials - aluminium, brass, and mild steel - were subjected to increasing loads to measure deflection. The table shows the dimensions of each beam material tested and the measured deflection in millimeters under loads ranging from 0 to 16 newtons. Deflection increased approximately linearly with applied load for each material.

Uploaded by

faqhrul
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as XLSX, PDF, TXT or read online on Scribd
21 views2 pages

Title: Bending Test: Materials Length Width Thickness Deflection of Beam (MM)

This document reports the results of a bending test experiment where three materials - aluminium, brass, and mild steel - were subjected to increasing loads to measure deflection. The table shows the dimensions of each beam material tested and the measured deflection in millimeters under loads ranging from 0 to 16 newtons. Deflection increased approximately linearly with applied load for each material.

Uploaded by

faqhrul
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as XLSX, PDF, TXT or read online on Scribd
You are on page 1/ 2

Title : Bending Test

Materials Length Width Thickness Deflection of Beam (mm)


Aluminium 998 19.30 6.52
Brass 1005 20.00 6.00 LOAD Materials
Mild Steel 999 20.36 4.00 (N) Aluminium Brass
0 0 0
Dimensions are in mm 2 0.15 0.12
4 0.32 0.24
6 0.48 0.35
8 0.64 0.47
10 0.8 0.59
12 1.06 0.7
14 1.12 0.82
16 1.28 0.94
aterials
Mild Steel
0
0.19
0.42
0.63
0.84
1.05
1.26
1.47
1.68

You might also like