Scribd
Upload
27 views

Lab Session 5: Modeling of Under Voltage Relay Using MATLAB

The document describes modeling an under voltage relay using MATLAB to protect an electrical system during faults. It lists the objectives as implementing the relay using Simulink libraries, setting the time and voltage thresholds, and coordinating the relay. The task is to create a Simulink model of an under voltage relay that monitors voltage, detects faults when voltage decreases, and sends a trip signal to open the circuit breaker.

Uploaded by

Hayat Ansari
Copyright
© © All Rights Reserved
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
27 views

Lab Session 5: Modeling of Under Voltage Relay Using MATLAB

The document describes modeling an under voltage relay using MATLAB to protect an electrical system during faults. It lists the objectives as implementing the relay using Simulink libraries, setting the time and voltage thresholds, and coordinating the relay. The task is to create a Simulink model of an under voltage relay that monitors voltage, detects faults when voltage decreases, and sends a trip signal to open the circuit breaker.

Uploaded by

Hayat Ansari
Copyright
© © All Rights Reserved
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
You are on page 1/ 3

Lab Session 5

Modeling of under Voltage Relay using MATLAB


Objectives:
At the end of this lab session students will be able to:

 Implement “Under voltage Relay” by using Matlab Simulink Libraries.


 Set the “time and voltage Setting” of Under voltage Relay.
 Co-ordination of Under voltage relay

5.0Under Voltage Relay


Under current relay is one which monitors the voltage only and gives trip signal to the circuit
breaker in faulty condition. In case of faults, if voltage in the system decreases from its normal
value it will open the breaker.

5.1 Laboratory Task


Implement under voltage relay in Matlab Simulink that protect the system in faulty conditions.
After sensing the fault relay should give a trip signal to the circuit breaker.

5.2 Simulation Diagram:


Main System:
Subsystem :

Output Voltage Waveform:

You might also like