Scribd
Upload
139 views

16.substations Monitoring

This project aims to continuously monitor and control distribution transformers to prevent burning due to overload, overtemperature, or high input voltages. It uses sensors to measure the current, voltage, temperature, and light levels, and a microcontroller to compare these values to limits. If any values exceed the limits, a relay will automatically shut down the transformer to protect it. The system transmits sensor data to a control room using RF technology so maintenance staff can remotely monitor transformer conditions.

Uploaded by

dileeppatra
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOC, PDF, TXT or read online on Scribd
139 views

16.substations Monitoring

This project aims to continuously monitor and control distribution transformers to prevent burning due to overload, overtemperature, or high input voltages. It uses sensors to measure the current, voltage, temperature, and light levels, and a microcontroller to compare these values to limits. If any values exceed the limits, a relay will automatically shut down the transformer to protect it. The system transmits sensor data to a control room using RF technology so maintenance staff can remotely monitor transformer conditions.

Uploaded by

dileeppatra
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOC, PDF, TXT or read online on Scribd
You are on page 1/ 4

SUBSTATIONS MONITORING

AIM:

The main aim of this project is to use the to continuously monitor and control the
distribution transformer or any other power transformer from burning due to the overload,
over temperature,ldr and high input voltages.

PURPOSE:

Normally most of the transformers are burning because of over load; hence by
incorporating monitoring and control circuits, correspondingly increasing the life time of the
transformer

METHODOLOGY:

BLOCK DIAGRAM:
SUBSTATION SECTION:

POWER

SUPPLY

A
MICRO
TEMPERATURE CONTROLLER
D
SENSOR RELAY

CURRENT C
SENSOR TRANSFORMER

VOLTAGE

SENSOR
LOADS
POWER SUPPLY:

Step Down Bridge Filter Regulator


Transformer Rectifier Circuit section

DESCRIPTION:

In this project we designed a system in such a way that it will monitor and control the
load of the substation continuously and that information is transferred to the control room
using RF Technology. In the main station these parameters are displayed on the PC. In PC
we can view the continuous information of transformer i.e. due to what reason the
transformer has been failed, when the power is resumed etc.,. With the help of this kind of
system, the maintenance staff of the department can have a continuous vigilance over the
transformer.

In this project work, we had taken a small step-down transformer of 12V, 1 amps rating
at secondary is considered and small bulbs are connected as a load. In this project we are
using CT transformer for measuring load current, voltage sensor and temperature,Ldr sensor.
All these parameters are converted into digital value by using ADC. If the parameters of the
transformer regain the limited range values then Transformer will automatically shutdown.

HARDWARE COMPONENTS:

 Microcontroller
 Power supply

 Relay

 Loads

 ADC

 Sensors

 Transformer

 MAX 232

SOFTWARE TOOLS:

 Keil micro vision


 Embedded C
 Express PCB
APPLICATIONS:

 This project is used for protecting Transformers in sub stations, generating stations etc.
 Used for Industrial protection

RESULT:

Hence by this project we can monitor and control the substation.

You might also like