Scribd
Upload
43 views2 pages

A/C Electronis System: MAX - MARK:50 Q.P.REF - NO.14112019 Time Duration:1 Hour

This document contains 30 multiple choice questions about electronics systems. The questions cover topics like differential amplifiers, operational amplifiers, integrated circuits, and silicon controlled rectifiers (SCRs). Some key points addressed are: - Differential amplifiers have two inputs and one output, and can operate in either differential or single-ended mode. - Operational amplifiers with negative feedback have very high input impedance, very low output impedance, and linear operation. - Integrated circuits are most commonly made from silicon using monolithic fabrication. They contain active components like transistors and diodes. - Silicon controlled rectifiers have three layers of semiconductor material and four pn junctions. They act as a bidirectional

Uploaded by

Vikash Pal
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
43 views2 pages

A/C Electronis System: MAX - MARK:50 Q.P.REF - NO.14112019 Time Duration:1 Hour

This document contains 30 multiple choice questions about electronics systems. The questions cover topics like differential amplifiers, operational amplifiers, integrated circuits, and silicon controlled rectifiers (SCRs). Some key points addressed are: - Differential amplifiers have two inputs and one output, and can operate in either differential or single-ended mode. - Operational amplifiers with negative feedback have very high input impedance, very low output impedance, and linear operation. - Integrated circuits are most commonly made from silicon using monolithic fabrication. They contain active components like transistors and diodes. - Silicon controlled rectifiers have three layers of semiconductor material and four pn junctions. They act as a bidirectional

Uploaded by

Vikash Pal
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
You are on page 1/ 2

A/C ELECTRONIS SYSTEM

MAX.MARK:50 Q.P.REF.NO.14112019 TIME DURATION:1 hour

Mark the appropriate answer

Q1.A differential amplifier …………..


(a) is a part of an op-amp (b) has one input &one output (c) has two output (d) (a) & (c)
Q2.when a D.A (Differential Amplifier) is operated single ended………..
(a) the output is grounded (b) one input is grounded and signal is applied to the other
(c) both inputs are connected together (d) the out is not inverted
Q3. In differential mode ………………..
(a) opposite polarity signals are applied to the inputs (b) the gain is one
(c) the outputs are of different amplitude (d) only one supply voltage is used
Q4.In common mode …………..
(a) both inputs are grounded (b) the output are connected together
( c) identical signals appears on both input(d) the output signals are in phase
Q5. The common mode gain is
(a) very high (b) very low
(c) dependent on output voltage (d) about 100
Q6. The differential gain is
(a) very high (b) very low
(c) dependent on input voltage (d) about 100
Q7. For an Op- amp with negative feedback the output is
(a) equal to the input (b) increased
(c) feedback to the inverting input (d) feedback to the non-inverting input
Q8. The use of negative feedback
(a) reduce the voltage gain of an Op-amp (b) makes the Op- amp oscillate
(c) makes linear operation possible (d) both (a) and (b)
Q9. Negative feedback
increase the output impedances and input (b) increase the input impedance and bandwidth
decrease the output impedance and bandwidth (d) does not affect the impedance or bandwidth
Q10. A voltage follower
(a) has a voltage gain of 1 (b) in non-inverting (c) has no feedback resistor (D) All
Q11. A common made signal is applied to
(a) the non—inverting input (b) the inverting input (c) both input (d) All
Q12. Which term is related to SCR :
(a) Holding current (b) As in (a) & PVR (c) AS in (b) &i2 t (d) as in (c) and reverse current
Q13.the common mode voltage gain is
smaller than differential voltage gain (b) equal to differential voltage gain (c) greater than differential
voltage gain (d) none
Q14. An ICs has _ rise
(a) very large (b) large (c) Extremely small (d) none
Q15. ICs are generally made of_
(a) Silicon (b) Germanium (c) Copper (d) None
Q16. _ Ice are the most commonly used
(a) thin film (b) monolithic (c) hybrid (d) none
Q17. _ cannot be fabricated n an IC
(a)transistors (b) diodes (c) resistor (d) large inductors and transistors
Q18.An audio amplifier is an example of _
(a) digital IC (b) linear IC (c) both digital and linear IC (d) none
Q19.the active component of an IC are_
(a)resistors (b) capacitors (c) transistors and diodes (d) none
Q20.we use _ICs in computers
(a) digital (b) linear (c) both digital and linear (d) none
Q21.The SiO2 layer in an IC acts as_
(a) a resistor (b) an insulating layer (c) mechanical output (d) none
Q22.ICs are used in _
(a) linear device only (b) digital device only (c) both linear and digital devices (d) none
Q23.a transistor takes _ inductor on a silicon IC chip
(a)less space than (b) more space than (c) same space as (d) none
Q24.An SCR has _ pn junction
(a) two (b) three (c) four (d) none
Q25.An SCR is a solid state equivalent of _
(a) triode (b) pentode (c) gas filled triode (d) tetrode
Q26. An SCR has _ semiconductor layers
(a) two (b) three (c) four (d) none
Q27.An SCR behaves as a _ switch
(a)unidirectional(b) bidirectional (c) mechanical (d) none
Q28.An SCR is sometimes called
(a) triac (b) diac (c) unijunction (d) thyristor
Q29.An SCR combines the feature of _
(a) rectifier and resistance (b) a rectifier and transistor (c) a rectifier and capacitor (d) none
Q30.the control element in an SCR is
(a)cathode (b) anode (c) anode supply (d) gate

You might also like