Scribd
Upload
200 views

Metal Cutting Process

This document discusses machining technology and metal cutting processes. It describes the primary and secondary deformation zones that occur during chip formation. It also discusses the different types of cutting tools used - single point and multi-point tools - and their key elements. Finally, it summarizes the two main types of cutting processes - orthogonal cutting where the tool is perpendicular to the workpiece surface, and oblique cutting where the tool is at an acute angle.

Uploaded by

Gobivel Kathirvel
Copyright
© © All Rights Reserved
Available Formats
Download as PDF, TXT or read online on Scribd
200 views

Metal Cutting Process

This document discusses machining technology and metal cutting processes. It describes the primary and secondary deformation zones that occur during chip formation. It also discusses the different types of cutting tools used - single point and multi-point tools - and their key elements. Finally, it summarizes the two main types of cutting processes - orthogonal cutting where the tool is perpendicular to the workpiece surface, and oblique cutting where the tool is at an acute angle.

Uploaded by

Gobivel Kathirvel
Copyright
© © All Rights Reserved
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 6

MANUFACTURING TECHNOLOGY – II

Theory of metal cutting

Mr. K Gobivel / Assistant Professor


Department of Mechanical Engineering
KCG College of Technology

primary deformation (shear) zone

secondary deformation zone


Primary and secondary deformation zones in the chip
Machining
Machining is a semi-finishing or finishing process
essentially done to impart required or stipulated
dimensional and form accuracy and surface finish to
enable the product to

• fulfill its basic functional requirements


• provide better or improved performance
• render long service life
The form of the chips is an important index of machining because it directly
or indirectly indicates :

• Nature and behaviour of the work material under machining condition


• Specific energy requirement (amount of energy required to remove unit
volume of work material) in machining work
• Nature and degree of interaction at the chip-tool interfaces.

The form of machined chips depend mainly upon :

• Work material
• Material and geometry of the cutting tool
• Levels of cutting velocity and feed and also to some extent on depth of cut
• Machining environment or cutting fluid that affects temperature and
friction at the chip-tool and work-tool interfaces.
Types of cutting tool
• Single point cutting tool
The cutting tool, which has only one cutting edge, is termed as single
point cutting tool. Single point cutting tools are generally used while
performing turning, boring, shaping and planing operation. The important
elements in single point cutting tools are rake angle, principle cutting edge,
nose etc.

• Multi point cutting tool


A cutting tool which has more than one cutting edge is multi point
cutting tool. Multi point cutting tools are generally used while performing
drilling, milling, broaching, grinding etc. Important elements are cutting edge,
helix angle, the number of teeth.
Types of cutting process
• Orthogonal Cutting
In orthogonal cutting, the tool approaches the work piece with its
cutting edge parallel to the uncut surface and at right angles to the
direction of cutting (90 degree).

• Oblique Cutting
In oblique cutting , the cutting edge of the tool is inclined at an acute
angle with the direction of tool feed or work feed, the chip begin
disposed of at a certain angle (less than 90 degree).

Oblique Cutting
Orthogonal Cutting

You might also like