Adv. Eng. Tec. Appl. 5, No.

1, 7-9 (2016) 7
Advanced Engineering Technology and Application
An International Journal

http://dx.doi.org/10.18576/aeta/050102

Study of Radiation Patterns Using Modified Design of Yagi-Uda

Antenna
G. M. Thakur1, V. B. Sanap2,* and B. H. Pawar1.
PI, Wireless section, DPW &Adl DG office, Pune (M.S.), India.
Yeshwantrao Chavan College, Sillod Dist Aurangabad (M.S.), India.

Received: 8 Aug. 2015, Revised: 20 Oct. 2015, Accepted: 28 Oct. 2015.

Published online: 1 Jan. 2016.

Abstract: Antenna is very important in wireless communication system. Among the most prevalent antennas, Yagi-Uda
antenna is widely used. To improve the antenna gain and directivity, design of antenna is always important. In this paper,
the Yagi Uda antenna is modified by adding two more reflectors instead of single and the gain, directivity & radiation
pattern were studied. This antenna is designed to give better gain in one particular direction as well as somewhat reduced
gain in other directions. The direction of "reduced gain" and gain at particular direction are not controllable in Yagi Uda.
This paper provides a design which modifies radiation pattern of Yagi as per user requirement. The experiment is carried
out at 157 MHz and all readings are taken for vertical polarization, with the help of Radio Communication Monitor.
Keywords: Wireless communication, Yagi-Uda, Communication Service Monitor, Vertical polarization.

three) are used. The said antenna is designed with

1 Introduction following set of parameters,
Antennas have numerous advantages such as they can be  Type:- Yagi-Uda antenna with additional two
suitably used for wide range of applications such as reflectors
wireless communications, satellite communications, pattern  Input :- FM modulated signal of 157 MHz, with stability
combining and antenna arrays. Antenna is an electrical of 2 PPM (Parts Per Millions)
device which forms an interface between free-space
 Frequency stability
radiations and transmitter or receiver. The choice of an
 Antenna polarization:- Vertical
antenna depends on various factors such as gain,
impedance, bandwidth, frequency of operation, Side Lobe  Signal measured:- From Communication Service
Level (SLL), etc. Monitor.
 Coaxial cable:- RG 58Au with N type connector.
Initially, the Yagi-Uda antenna was used for  Radio used:- Motorola GP339 handheld trans receiver.
domestic application that is for receiving signals for
televisions but recently they also found there application in
wireless system [1-5]. Yagi-Uda antenna is a widely used
antenna design at VHF and UHF due to its high forward
gain capability (typically, greater than 10dB), low cost and
ease of construction [6-8,18].
In this paper, special emphasis is given in designing of
three reflector Yagi-Uda antenna and the modified radiation
pattern and related parameters have been studied.
2 Antenna Design Parameters
In this paper, proposed antenna is modified form of simple
Yagi Uda antenna. In this design instead of single reflector,
two additional reflectors (total number of reflectors are Fig. 1Multi reflector antenna
*Correspondingauthore-mail:[email protected]
© 2016NSP
Natural Sciences Publishing Cor.
8 G. Thakur et al.: Study of radiation patterns …

forward to backward ratio (f/b) can be controlled by

The design of proposed multi reflector antenna is shown in changing angle θ. [14-17].
Figure-1. It is designed at frequency 157 MHz. The signal
is transmitted from Motorola make type GP339 VHF
handheld trans receiver. The signal is collected at the
proposed antenna and feed to communication service
monitor [ Make& Type- IFR-2945B]. [9-13]
The same setup is carried out for 3 element Yagi, ground
plane (GP) and results were compared. The same antenna is
tested at field and lab results are confirmed.
Table 1: Details of various parameters for designing
1 Frequency Used f 157 MHz
2 Length of Director L1 77 cms
3 Length of Folded dipole L2 87 cms
4 Length Reflectors L3 95 cms
5 Separation between L1 & L2 W1 24 cms
6 Separation between L2 & L3 W2 29 cms Fig. 3 Radiation patterns for Yagi with single reflector and
Horizontal Separation multi reflector at different angles.
7 between Reflectors, R and R1, θ 30°& 60°
The results of receiving field strength are collected by
R and R2
changing position of transmitter. The same experiment is
The arrangement for installing additional reflectors with carried out by changing the said aerial with ground plane
respect to folded dipole is as shown in Figure 2. FD and Yagi and results were compared. Then the position of
indicates folded dipole, D indicates director and R1. R, R2 reflector is changed by angle of 30°, 60°progressively and
indicates reflectors. The readings are taken by changing results were tabulated (Table 2).
angle θ i.e. for θ = 30° and θ = 60°.
Table 2: Variation in different parameters of Yagi- Uda
antenna with three reflectors.
Yagi-uda Yagi-uda
with with
Three
additional additional
Sr. Element
Parameter two two
no. Yagi-
reflectors reflectors
Uda
at 300 at 600
angle angle
1 Gain 6 dbi 12 dbi 14 dbi
2 Directivity 7.37 dbi 10.875 dbi 15.75 dbi
3 HPBW 123° 83° 60°
Fig. 2 Arrangement of reflectors.
4 F/B ratio 19dbm 35dbm 41dbm
3 Results and Discussion
It is found that as reflector position is changed, from θ =
In the literature review, it is seen that in case of simple 3 30° to θ = 60° the radiation pattern shifts, forward gain
elements Yagi antenna the radiation pattern is directional increases and beam width reduces. The reduction in beam
and focused maximum in the direction of director element. width is proportional to the angle of reflectors. More the
The back lobe has very very low gain due to physical angle, less is the 3db beam width and greater is the
dimension of reflector and its distance from folded dipole directive gain. [14,16]
or radiating element.
The modified set up of Yagi Uda consists of three reflectors Table 2 shows the result of Yagi-Uda antenna with
and a director which give the radiation pattern as shown in additional two reflectors. It shows approximate 6 to 8 db
figure 3. This pattern clearly indicates, as the angle between forward gain improvement compared to 3 element Yagi,
Reflector R, R1 and R, R2 changes, the radiation pattern .i.e. up to 12db to 14db compared to isotropic antenna. This
also modifies and give considerable gain in the required structure modifies back lobe & gives gain in backward
direction. It is possible to increase gain in particular direction as well as the direction of our requirement, by
direction by adjusting position of additional reflectors and controlling reflector angle.
amount of gain, half power bandwidth (HPBW) and

© 2016 NSP
Natural Sciences Publishing Cor.
Adv. Eng. Tec. Appl. 5, No. 1, 7-9 (2016) / http://www.naturalspublishing.com/Journals.asp 9

[9]E. Krasnok, A. E. Miroshnichenki, P. A. Belov and Yu. S.

Table 3: Variation in power of Yagi-Uda antenna for Kivshar,” Huygens Optical Elements and Yagi-
different aerials. UdaNanoantennas Based on Dielectric Nanoparticles”, JETP
Letters, 2011, Vol. 94, No.8 pp. 593-598.
Forward Reflected
Sr.
No.
Type of aerial power in power in [10]Richard A. Formato,” Improving Bandwidth of Yagi-Uda
watts watts Arrays”, Wireless Engineering and Technology, Vol. 3 No.1
1 GP 21 0.1 (2012), DOI:10.4236/wet.2012.31003.
2 3 Element Yagi 21 0.1 [11] E.E. Altshuler and D.S. Linden. Wire-antenna Designs using
3 Element Yagi with Genetic Algorithms. Antennas and Propagation Magazine,
3 additional two 21 0.1 IEEE, 39(2):33–43, (1997).
reflectors
[12] C. Chen and D. Cheng. Optimum Element Lengths for Yagi-
Table 3 shows variation in forward power and reflected Uda Arrays. IEEE Transactions on Antennas and Propagation,
power of Yagi Uda antenna with multiple reflectors. The 23(1):8–15, (1975).
power is checked by using Bird's through line wattmeter. [13] N.V. Venkatarayalu and T. Ray. Optimum Design of Yagi-
Hence we can conclude that antenna impedance does not Uda Antennas Using Computational Intelligence. IEEE
considerably changes compared to simple Yagi Uda Transactions on Antennas and Propagation, 52(7):1811–1818,
antenna. (2004).

4 Conclusion [14]Mahesh Kumar Aghwariya, P. K. Singhal,” Dual Director

Microstrip Planar Yagi-Uda Antenna for X-Band”, IJECCT
2013, Vol. 3(2).
In this paper, three reflector Yagi-Uda antenna have been
designed successfully. It is observed that the directivity and [15]Satyandra Singh Lodhi, Mahesh Kumar Aghwariya, Ragini
gain of antenna increases & can be controlled by changing Sharma,” Microstrip Branch Structure Yagi-Uda Antenna with
position of reflectors, which is very useful for wireless Proper Impedance Matching”, IJAIM, Vol 1, Issue 5, ISSN
communication and other applications. 2320-5121.
[16]G. Sharma, Vijay Sharma, and P.K. Singhal,” Design and
References Characterization of Multiband Yagi-Uda Radiator”, IJOAR,
Vol 1, Issue 3, March 2013.
[1] Chou H.T., K.T. Hung, and C.Y. Chen, “Utilization of a Yagi
antenna director array to synthesize a shaped radiation pattern [17]Zedong Wang, Xianglongliu, Yingzeng Yin, Junhui Wang,
for optimum coverage in wireless communication,” Journal of and Zhaoxing Li,” A Novel Design of Folded Dipole for
Electromagnetic Waves and application, Vol. 23, No. 7, 851- Broadband Printed Yagi-Uda Antenna”, Progress In
861 (2009). Electromagnetics Research c, Vol. 46, 23-30, 2014.

[2] Li, J.-Y and J. L. Guo, “Optimization technique using [18]S. S. Khade, SuvarnaTalatule, S. L. Dadjate,”Compact Planar
differential evolution for Yagi-uda antennas.” Journal of Directive YagiAntenna for WLAN Application”, International
Electromagnetic Waves and application, Vol.23, No. 4, 449- Journal of Electrical, Electronics and Data Communication,
461, (2009). Vol. 1, Issue. 2, April- 2013.

[3] Misra, I.S., R. S. chakrabarty, and B. B. Mangaraj , “Design

analysis and Optimization of V-dipole and its three-element
Yagi-udaarray.”ProgressIn Electromagnetic Research, PIER
66, 137-156, (2006).
[4] W. L. Stutzman and G.A. Thiele, Antenna theory and design
.New York; Wiley, 1998
[5] Derek GrAy, Jun Wei Lu, and David V. Thiel., Electronically
steerable Yagi-Uda micro strip patch antenna array.
[6] David M. Pozar, “Microwave Engineering”, 3rd Edition, John
Wiley &Sons, (2004).
[7] Satyandra Singh Lodhi, P. K. Singhal,”Microstip Yagi-Uda
antenna at 2.45 GHz for ISM Band Application”, International
Journal of Research in Engineering & Technology
(IJRET),Vol. 1, Issue 2, July 2013, 151-154.
[8]Y. Chen and C. F. Wang, “Electrically Loaded Yagi-Uda
Antenna Optimizations Using Characteristics Modes And
Differential Evolution”, Journal of Electromagnetic Waves
and Applications, Vol. 26, 1018-1028, (2012).

© 2016 NSP
Natural Sciences Publishing Cor.