Scribd
Upload
46 views

Freezer Rooms & Display Freezers Remarks: NEVER Go To A BIGGER Compressor

This document provides guidelines for selecting components for freezer systems based on the interior volume of the freezer. It recommends: - Matching the compressor size to the condensing unit's capacity to avoid overloading. - Choosing a condensing unit and fan that do not over-condense the refrigerant. - Sizing the compressor slightly larger for freezers with heavy loads or warm product being placed inside. - Selecting an expansion valve orifice size based on the compressor HP size using the formula in the document.

Uploaded by

Muhammad Zubair
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
46 views

Freezer Rooms & Display Freezers Remarks: NEVER Go To A BIGGER Compressor

This document provides guidelines for selecting components for freezer systems based on the interior volume of the freezer. It recommends: - Matching the compressor size to the condensing unit's capacity to avoid overloading. - Choosing a condensing unit and fan that do not over-condense the refrigerant. - Sizing the compressor slightly larger for freezers with heavy loads or warm product being placed inside. - Selecting an expansion valve orifice size based on the compressor HP size using the formula in the document.

Uploaded by

Muhammad Zubair
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
You are on page 1/ 1

Freezer Rooms & Display Freezers

Inside Volume Compressor size R 404 -- R 507 Gas Orific  Remarks


Length x Width x Height e
The System Condensor & Fan  is ALWAYS the Deciding Factor
1749 Watts   0X
4.2 cubic meter
0.5 Hp

  0X Never Put a Compressor Bigger than the Condensor Can


2002 Watts Handle (Overload compressor)
4.8 cubic meters
0.57 Hp

  0X BUT
2465 watts
6 cubic meters
0.7 Hp

  Never Put a Condensor / Fan Match the Causes "Cold " Liquid
3225 watts 0X Refrigerant (over condense gas ) -try cycle condensor Fan
7.6 cubic meters
0.9 Hp  
For a Heavy load or Pull down  (Warm Product in ) go to next
5886 watts 00 smaller size in Cubic Meters
14.5 cubic meters 1.7 Hp

   
17.5 cubic meters 6955 watts 00
2 Hp

        If there is any doubt of compressor size, ALLWAYS go one size


SMALLER
NEVER go to a BIGGER Compressor
         
        Never install a compressor on a Blocked / Dirty or Contaminiated
/ WET (Water) System
         
  Allways Replace the Drier
     
Contaminated systems must have a bigger Drier after Cleaning
         
        NEVER put the WRONG gass in the SYSTEM or
COMPRESSOR
         
        ALLWAYS Replace the Drier
ALLWAYS instal Burnout Drier After Any Compressor BURNOUT
Failure to install Burnout Driers Will Cause another Burnout very
soon afterward
         
  ALLWAYS Match your Expansion Value orrifce to the Compressor /
System
     
Wrong Orifice Cause POOR Refrigeration and wrong Superheat
that will cuase Compressor to Fail
 
     
Orifice Tricks
  Divide your Compressor HP size in half. and add 10%
      Use this figure to Select your office size from the Chart on the
Box
        Slightly bigger gives less Depth of Cold but more cooling effect
        Slightly Smaller Gives Deeper cold But less Cooling Effect
         
     

You might also like