View Answer
View Answer
a. Differential amplifier
b. Rectifier
c. Bridge
View Answer:
902. The most commonly used filter in SSB generators uses
a. LC network
b. Mechanical resonators
c. Crystals
View Answer:
903. The equivalent circuit of a quartz crystal is a
c. Neither a nor b
d. Both a and b
View Answer:
904. A crystal lattice filter has crystal frequencies of 27.5 and
27.502 MHz. The bandwidth is approximately
a. 2 kHz
b. 3 kHz
c. 27.501 MHz
d. 55.502 MHz
View Answer:
905. An SSB generator has a sideband filter centered at 3.0 MHz.
The modulating signal is 3 kHz. To produce both upper and lower
sidebands, the following carrier frequencies must be produced:
View Answer:
906. In the phasing method of SSB generation, one sideband is
canceled due to
a. Phase shift
b. Sharp selectivity
c. Carrier suppression
d. Phase inversion
View Answer:
907. A balanced modulator used to demodulate a SSB signal is
called a(n)
a. Transporter
b. Product detector
c. Converter
d. Modulator
View Answer:
908. Frequency translation is done with a circuit called a
a. Summer
b. Multiplier
c. Filter
d. Mixer
View Answer:
909. The inputs to a mixer are fo and fm. In down conversion,
which of the following mixer output signals is selected?
a. Fo
b. Fm
c. Fo – fm
d. Fo + fm
View Answer:
910. Mixing for frequency conversion is the same as
a. Rectification
b. AM
c. Linear summing
d. Filtering
View Answer:
911. Which of the following can be used as a mixer?
a. Balanced modulator
b. FET
c. Diode modulator
View Answer:
912. The desired output from a mixer is usually selected with a
a. Phase-shift circuit
b. Crystal filter
c. Resonant circuit
d. Transformer
View Answer:
913. The amount of frequency deviation from the carrier center
frequency in an FM transmitter is proportional to what characteristic
of the modulating signal?
a. Amplitude
b. Phase
c. Angle