Scribd
Upload
49 views

B. General Coding Guidelines: 1. Locating A Code in The ICD-10-CM

The document provides general coding guidelines for using ICD-10-CM codes, including: locating codes using both the Alphabetic Index and Tabular List; coding diagnoses to the highest level of specificity; and rules for coding multiple conditions, late effects, impending conditions, bilateral sites, BMI, and pressure ulcers. Proper use of codes requires following all instructional notes and referring between the Index and Tabular List.

Uploaded by

Maria Nadia Mihalik
Copyright
© © All Rights Reserved
Available Formats
Download as PDF, TXT or read online on Scribd
49 views

B. General Coding Guidelines: 1. Locating A Code in The ICD-10-CM

The document provides general coding guidelines for using ICD-10-CM codes, including: locating codes using both the Alphabetic Index and Tabular List; coding diagnoses to the highest level of specificity; and rules for coding multiple conditions, late effects, impending conditions, bilateral sites, BMI, and pressure ulcers. Proper use of codes requires following all instructional notes and referring between the Index and Tabular List.

Uploaded by

Maria Nadia Mihalik
Copyright
© © All Rights Reserved
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 4

B.

General Coding Guidelines

1. Locating a code in the ICD-10-CM


To select a code in the classification that corresponds to a diagnosis or reason
for visit documented in a medical record, first locate the term in the
Alphabetic Index, and then verify the code in the Tabular List. Read and be
guided by instructional notations that appear in both the Alphabetic Index
and the Tabular List.

It is essential to use both the Alphabetic Index and Tabular List when
locating and assigning a code. The Alphabetic Index does not always
provide the full code. Selection of the full code, including laterality and any
applicable 7th character can only be done in the Tabular List. A dash (-) at
the end of an Alphabetic Index entry indicates that additional characters are
required. Even if a dash is not included at the Alphabetic Index entry, it is
necessary to refer to the Tabular List to verify that no 7th character is
required.

2. Level of Detail in Coding


Diagnosis codes are to be used and reported at their highest number of
characters available.

ICD-10-CM diagnosis codes are composed of codes with 3, 4, 5, 6 or 7


characters. Codes with three characters are included in ICD-10-CM as the
heading of a category of codes that may be further subdivided by the use of
fourth and/or fifth characters and/or sixth characters, which provide greater
detail.

A three-character code is to be used only if it is not further subdivided. A


code is invalid if it has not been coded to the full number of characters
required for that code, including the 7th character, if applicable.

3. Code or codes from A00.0 through T88.9, Z00-Z99.8


The appropriate code or codes from A00.0 through T88.9, Z00-Z99.8 must be
used to identify diagnoses, symptoms, conditions, problems, complaints or
other reason(s) for the encounter/visit.

4. Signs and symptoms


Codes that describe symptoms and signs, as opposed to diagnoses, are
acceptable for reporting purposes when a related definitive diagnosis has not
been established (confirmed) by the provider. Chapter 18 of ICD-10-CM,
Symptoms, Signs, and Abnormal Clinical and Laboratory Findings, Not
Elsewhere Classified (codes R00.0 - R99) contains many, but not all codes for
symptoms.

ICD-10-CM Official Guidelines for Coding and Reporting


2011
Page 12 of 111
5. Conditions that are an integral part of a disease process
Signs and symptoms that are associated routinely with a disease process
should not be assigned as additional codes, unless otherwise instructed by the
classification.

6. Conditions that are not an integral part of a disease process


Additional signs and symptoms that may not be associated routinely with a
disease process should be coded when present.

7. Multiple coding for a single condition


In addition to the etiology/manifestation convention that requires two codes to
fully describe a single condition that affects multiple body systems, there are
other single conditions that also require more than one code. “Use additional
code” notes are found in the Tabular List at codes that are not part of an
etiology/manifestation pair where a secondary code is useful to fully describe
a condition. The sequencing rule is the same as the etiology/manifestation
pair, “use additional code” indicates that a secondary code should be added.

For example, for bacterial infections that are not included in chapter 1, a
secondary code from category B95, Streptococcus, Staphylococcus, and
Enterococcus, as the cause of diseases classified elsewhere, or B96, Other
bacterial agents as the cause of diseases classified elsewhere, may be required
to identify the bacterial organism causing the infection. A “use additional
code” note will normally be found at the infectious disease code, indicating a
need for the organism code to be added as a secondary code.

“Code first” notes are also under certain codes that are not specifically
manifestation codes but may be due to an underlying cause. When there is a
“code first” note and an underlying condition is present, the underlying
condition should be sequenced first.

“Code, if applicable, any causal condition first”, notes indicate that this code
may be assigned as a principal diagnosis when the causal condition is
unknown or not applicable. If a causal condition is known, then the code for
that condition should be sequenced as the principal or first-listed diagnosis.

Multiple codes may be needed for late effects, complication codes and
obstetric codes to more fully describe a condition. See the specific guidelines
for these conditions for further instruction.

8. Acute and Chronic Conditions


If the same condition is described as both acute (subacute) and chronic, and
separate subentries exist in the Alphabetic Index at the same indentation level,
code both and sequence the acute (subacute) code first.

ICD-10-CM Official Guidelines for Coding and Reporting


2011
Page 13 of 111
9. Combination Code
A combination code is a single code used to classify:
Two diagnoses, or
A diagnosis with an associated secondary process (manifestation)
A diagnosis with an associated complication

Combination codes are identified by referring to subterm entries in the


Alphabetic Index and by reading the inclusion and exclusion notes in the
Tabular List.

Assign only the combination code when that code fully identifies the
diagnostic conditions involved or when the Alphabetic Index so directs.
Multiple coding should not be used when the classification provides a
combination code that clearly identifies all of the elements documented in the
diagnosis. When the combination code lacks necessary specificity in
describing the manifestation or complication, an additional code should be
used as a secondary code.

10. Late Effects (Sequela)


A late effect is the residual effect (condition produced) after the acute phase of
an illness or injury has terminated. There is no time limit on when a late
effect code can be used. The residual may be apparent early, such as in
cerebral infarction, or it may occur months or years later, such as that due to a
previous injury. Coding of late effects generally requires two codes sequenced
in the following order: The condition or nature of the late effect is sequenced
first. The late effect code is sequenced second.

An exception to the above guidelines are those instances where the code for
late effect is followed by a manifestation code identified in the Tabular List
and title, or the late effect code has been expanded (at the fourth, fifth or sixth
character levels) to include the manifestation(s). The code for the acute phase
of an illness or injury that led to the late effect is never used with a code for
the late effect.

See Section I.C.9. Sequelae of cerebrovascular disease


See Section I.C.15. Sequelae of complication of pregnancy, childbirth and the
puerperium
See Section I.C.19. Code extensions

11. Impending or Threatened Condition


Code any condition described at the time of discharge as “impending” or
“threatened” as follows:
If it did occur, code as confirmed diagnosis.
If it did not occur, reference the Alphabetic Index to determine if the
condition has a subentry term for “impending” or “threatened” and also
reference main term entries for “Impending” and for “Threatened.”

ICD-10-CM Official Guidelines for Coding and Reporting


2011
Page 14 of 111
If the subterms are listed, assign the given code.
If the subterms are not listed, code the existing underlying condition(s)
and not the condition described as impending or threatened.

12. Reporting Same Diagnosis Code More than Once


Each unique ICD-10-CM diagnosis code may be reported only once for an
encounter. This applies to bilateral conditions when there are no distinct
codes identifying laterality or two different conditions classified to the same
ICD-10-CM diagnosis code.

13. Laterality
For bilateral sites, the final character of the codes in the ICD-10-CM indicates
laterality. An unspecified side code is also provided should the side not be
identified in the medical record. If no bilateral code is provided and the
condition is bilateral, assign separate codes for both the left and right side.

14. Documentation for BMI and Pressure Ulcer Stages


For the Body Mass Index (BMI) and pressure ulcer stage codes, code
assignment may be based on medical record documentation from clinicians
who are not the patient’s provider (i.e., physician or other qualified healthcare
practitioner legally accountable for establishing the patient’s diagnosis), since
this information is typically documented by other clinicians involved in the
care of the patient (e.g., a dietitian often documents the BMI and nurses often
documents the pressure ulcer stages). However, the associated diagnosis (such
as overweight, obesity, or pressure ulcer) must be documented by the patient’s
provider. If there is conflicting medical record documentation, either from the
same clinician or different clinicians, the patient’s attending provider should
be queried for clarification.

The BMI codes should only be reported as secondary diagnoses. As with all
other secondary diagnosis codes, the BMI codes should only be assigned
when they meet the definition of a reportable additional diagnosis (see Section
III, Reporting Additional Diagnoses).

C. Chapter-Specific Coding Guidelines


In addition to general coding guidelines, there are guidelines for specific diagnoses
and/or conditions in the classification. Unless otherwise indicated, these guidelines
apply to all health care settings. Please refer to Section II for guidelines on the
selection of principal diagnosis.

ICD-10-CM Official Guidelines for Coding and Reporting


2011
Page 15 of 111

You might also like