Royco 756 and Royco 756A: Hydraulic Fluid, Aircraft, Missile, and Ordnance Petroleum Base
Royco 756 and Royco 756A: Hydraulic Fluid, Aircraft, Missile, and Ordnance Petroleum Base
GENERAL INFORMATION
ROYCO 756 is a red-dyed, mineral oil based hydraulic fluid developed for the severe duty demands of aero-
space and industrial service. ROYCO 756 contains additives that provide excellent low temperature fluidity as
TYPICAL PROPERTIES:
®
ANDEROL is a reg. trademark of ANDEROL Inc.
For more information please refer to This information is furnished without warranty, representation, inducement, or
the relevant Material Safety Data license of any kind, except that it is accurate to the best of OUR knowledge or
Sheet accompanying each product. obtained from sources believed by ANDEROL to be accurate. ANDEROL
does not assume any legal responsibility for use of reliance upon it. Only
chemists or chemically qualified lab technicians should carry out tests. Before
using any chemical, read its label and Material Safety Data Sheet.
TYPICAL PROPERTIES:
PROPERTIES ROYCO 756 ROYCO 756A
Particle Contamination (automatic counter) Size range, mu
5-15 1200
16-25 175
26-50 60
51-100 5
100+ 0
Dielectric Strength, KV 49.6
APPLICATIONS
ROYCO 756 is designed for use in aircraft, missiles, autopilots, shock absorbers, cherry pickers, boom trucks,
robotics, and auto wreckers requiring all - weather performance. ROYCO 756 is particularly recommended for use
in systems where a "super clean" fluid can contribute to improved component life and reliability. ROYCO 756 can
be used in unpressurized systems operating at temperature ranges from -54 to 90°C (-65 to 195°F) and in pres-
surized systems from -54 to 135°C (-65 to 275°F) at pressures up to 3000 psi. ROYCO 756A may be used in
systems not requiring a “super clean” id and where the convenience of a resealable container can provide cost
savings.
ADVANTAGES
• Wide operating temperature range • “Super Clean” fluid to improve equipment life
(Royco 756)
• Low temperature fluidity • Excellent oxidation and corrosion inhibition
• Exceptional antiwear performance •
COMPATABILITY
ROYCO 756 should not be used in systems using natural rubber elastomers.
APPROVALS
ROYCO 756 meets all requirements and is qualified under MIL-SPEC: Mil-PRF-5606H that supersedes Mil-H-5606,
Mil-O-5606, AN-O-336, AN-VV-O-336, and AAF-3580. ROYCO 756A meets Mil-H-5606A.
R756: 11/30/02 : edited 10/20/04 by GMG
ANDEROL Inc.
PO Box 518, 215 Merry Lane
East Hanover, New Jersey USA
Tel: 888-ANDEROL
Or Tel: (973) 887-7410
Fax: (973) 884-3825
E-mail: [email protected]