Scribd
Upload
57 views

Sofiplus 2018: Non-Effective Parts-Line

This document describes how to define non-effective parts in a cross section using SOFiPLUS 2018 software. Users can create a non-effective parts line using either pick points, pick lines/curves, or single element polygonal input. The non-effective parts line excludes selected parts of the cross section from one or more analysis actions like normal forces or primary bending. Modifying existing non-effective parts lines is also possible.

Uploaded by

nepoznati1111
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
57 views

Sofiplus 2018: Non-Effective Parts-Line

This document describes how to define non-effective parts in a cross section using SOFiPLUS 2018 software. Users can create a non-effective parts line using either pick points, pick lines/curves, or single element polygonal input. The non-effective parts line excludes selected parts of the cross section from one or more analysis actions like normal forces or primary bending. Modifying existing non-effective parts lines is also possible.

Uploaded by

nepoznati1111
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 2

Non-effective Parts-Line — SOFiPLUS 2018 https://www.sofistik.de/documentation/2018/en/s...

SOFiPLUS 2018
NON-EFFECTIVE PARTS-LINE

TOOLTIP De�nes non-effective


SOF_CM_SECTIONNONEFFECTIVELINE
parts in a cross section.
Summary Command Create Non-Effective Parts-Line

Using the command ‘non- Tooltip De�nes non-effective parts in a cross


effective parts’, parts of a section.
polygon can be de�ned as non- Ribbon None
effective for one or more actions
Menu None
(normal forces, primary bending,
secondary bending). Parts of the SOF_CM_SECTIONNONEFFECTIVELINE_EDIT
cross section which are to be
Command Modify Non-Effective Parts-Line
excluded are selected using a
Tooltip Modi�es the properties of non-effective
line with thickness.
parts - line

A detailed description of these Ribbon None


properties can be found in the Menu None
chapter ‘NEFF - Non Effective
Parts’ of the manual AQUA.

For the creation of non-effective parts, the following options are


available:

Pick Points

Creates an element with the input of a minimum of 3 polygonal points.

Pick Lines or Curves

Creates an element by enclosing an area with the selected objects. Valid selection
choices include closed polylines and lines.

Single Element Mode - Polygonal Input

Switches between the polygonal input type and entry of a single element. Single ele-
ment mode always asks for the start and end point of a new element.

Information regarding the assignment of construction stages refer to the chapter Con-

1 of 2 10/06/2020, 01:08
Non-effective Parts-Line — SOFiPLUS 2018 https://www.sofistik.de/documentation/2018/en/s...

struction Stages of Cross Section Parts.

2 of 2 10/06/2020, 01:08

You might also like