Scribd
Upload
46 views

SCADA Project Guide - 07

The document discusses technical specifications for data exchange between a SCADA/DMS system and other systems under an R-APDRP project. It outlines that the SCADA system will exchange data with a GIS system using CIM/XML models over an ESB/bus. It also requires the SCADA system to exchange both real-time and non-real-time data with state load dispatch centers and disaster recovery centers using protocols like ICCP to allow information sharing and system rebuilding.

Uploaded by

renv
Copyright
© © All Rights Reserved
Available Formats
Download as PDF, TXT or read online on Scribd
46 views

SCADA Project Guide - 07

The document discusses technical specifications for data exchange between a SCADA/DMS system and other systems under an R-APDRP project. It outlines that the SCADA system will exchange data with a GIS system using CIM/XML models over an ESB/bus. It also requires the SCADA system to exchange both real-time and non-real-time data with state load dispatch centers and disaster recovery centers using protocols like ICCP to allow information sharing and system rebuilding.

Uploaded by

renv
Copyright
© © All Rights Reserved
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 1

Power Finance Corporation

SCADA/DMS, system under Part A –R-APDRP


Model Technical specification
MGVCL/RAPDRP/SIA/1140

The GIS System shall exchange data with SCADA System over IEC 61968-1 SOA
based ESB/Bus using CIM/XML Models for Power System using GIS Engine /
Adapters supporting the standard.

Direct SQL/ODBC interfaces should continue to be supported for report generation


and ad-hoc queries.

If utility was having GIS/ billing/customer system prior to R-APDRP i.e.


considered as legacy in IT –R-APDRP, then interfaces may be selected
accordingly viz ODBC/DDE etc using ASCII files. However, they shall provide
system in compliance of the data exchange requirement specified in this para.

Data to be exchanged with IT system is defined ISR section. For DR & SLDC , it
is given below:
1.2.4.2 For data exchange between SCADA/DMS control centres & DR centre ,
SLDC :

SCADA/DMS control centre shall also exchange data using ICCP with State
Load Despatch Centre (SLDC) of the state..Data exchange shall also allow
other information to be transferred report by exception but also configurable
periodically, or on demand. . It shall be possible to exchange at least the
following data:

• real-time telemetered data of the interconnected network,


• non-telemetered data of the interconnected network,
• calculated data of the interconnected network
• SOE data of the interconnected network
• historical data of the interconnected network
• scheduling data
• operator messages.
• Event /alarm lists
It is envisaged that the utility shall get the load forecasting & drawl schedules
from SLDC & versa in order to execute planning of load distribution.. In addition ,
status /measurement of interconnected network shall be able exchanged in both
directions.

The data exchange with DR is required all the data to be transferred from control
centre to DR which is required for system build in order to build a system from
scratch. ICCP . TASE.2 protocol or equivalent non proprietary / De-Facto
protocol shall be used transfer network model / database changes on
incremental /global basis automatically once a day & on demand It shall transfer
all data /information which is required for system build in order to build a system
from scratch.

1.2.5 Data Processing

SECTION-2, CHAPTER-1 : SCADA FUNCTIONS page 7 of 17

You might also like