Scribd
Upload
34 views

Learning Outcome No. 1: Plan and Prepare For Maintenance and Repair

This document outlines the learning outcome of planning and preparing for maintenance and repair. It lists the contents to include maintenance procedures, tools/equipment, materials, OHS policies, and checking computer systems. Assessment criteria require maintenance be planned according to job requirements, obtaining the correct tools/equipment, materials, following OHS procedures, and checking computer systems against specifications. Conditions provide a workplace, materials, tools, and equipment for assessment through written test and demonstration.

Uploaded by

Candice Sumayang
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
34 views

Learning Outcome No. 1: Plan and Prepare For Maintenance and Repair

This document outlines the learning outcome of planning and preparing for maintenance and repair. It lists the contents to include maintenance procedures, tools/equipment, materials, OHS policies, and checking computer systems. Assessment criteria require maintenance be planned according to job requirements, obtaining the correct tools/equipment, materials, following OHS procedures, and checking computer systems against specifications. Conditions provide a workplace, materials, tools, and equipment for assessment through written test and demonstration.

Uploaded by

Candice Sumayang
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
You are on page 1/ 2

LEARNING OUTCOME NO.

1
PLAN AND PREPARE FOR MAINTENANCE AND REPAIR

Contents:

1. Maintenance Procedures
2. Tools, equipment and testing device
3. Materials
4. OHS Policies and Procedures
5. Computer systems and networks

Assessment Criteria

1. Maintenance and/or Diagnosis of faults is planned and prepared in line


with job requirements.
2. Tools, equipment and testing devices needed for the maintenance are
obtained and checked for correct operation and safety.
3. Materials necessary to complete the work are obtained in accordance
with established procedures and checked against job requirements.
4. OHS policies and procedures are followed in line with job requirements.
5. Computer systems and networks for maintenance are checked against
job/service order or instructions and specifications.

Conditions

The participants will have access to:

1. Workplace Station
 Skillshare center, Osmeňa Colleges
2. Materials
 UTP Cable
 RJ-45
 Wires and cables
 Disks
 Connectors
 Adaptors
 Computer storage media
 Appropriate software
3. Tools
 LAN Tester
 Crimping Tool
 Multi-meter
 Plies
 Screwdriver
 Special tools
 Soldering Iron/Gun
 Hot air soldering station
 Utility knife/stripper
4. Equipment
 Monitor
 System Unit
 Mouse
 Keyboard
 AVR
 Power supply equipment
 Multi-meter
 Signal generator

Assessment Method:

1. Written Test
2. Demonstration

You might also like