Scribd
Upload
333 views

Stair Case Wiring

This document provides instructions for wiring a lamp using two three-way switches to control it from different locations on a staircase. The materials and tools needed are listed, along with a circuit diagram. The procedure involves running wires through PVC piping and connecting the switches, lamp holder, and power according to the diagram. Once assembled, testing the different switch positions shows the lamp turns on and off appropriately from each location.

Uploaded by

Kisto
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
333 views

Stair Case Wiring

This document provides instructions for wiring a lamp using two three-way switches to control it from different locations on a staircase. The materials and tools needed are listed, along with a circuit diagram. The procedure involves running wires through PVC piping and connecting the switches, lamp holder, and power according to the diagram. Once assembled, testing the different switch positions shows the lamp turns on and off appropriately from each location.

Uploaded by

Kisto
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
You are on page 1/ 3

STAIR CASE WIRING

AIM:
To control the status of the given lamp by using two – way switches.

MATERIALS REQUIRED:

Sl.No Name of the apparatus Range / Type Quantity

1 Incandescent Lamp 100W 1 No.

2 Lamp Holder Pendent Type 1 No.


3 SPDT Switch 230V,5A 2 Nos
4 Wires 1/18” As per requirement
5 P.V.C Pipe 1/4" As per requirement
6 Wooden Board - 1 No.
7 Round block - 1 No.

TOOLS REQUIRED:

Sl.No Name of the tools Quantity


1 Combination Plier 1 No
2 Connector screw drivers 1 No
3 Screw driver 1 No
4 Electrician knife 1 No

PRECAUTIONS:

1. While giving the connections be careful.


2. Handle the lamp safely.
3. Be careful while handling the tools.
CIRCUIT DIAGRAM:

PROCEDURE:

1. Place the accessories on the wiring board as per the circuit diagram.
2. Place the P.V.C. pipe and insert two wires into the P.V.C. pipe.
3. Take one wire, connect one end to the phase side and other end to the middle point of
SPDT Switch 1
4. Upper point of SPDT Switch 1 is connected to the lower point of SPDT Switch2.
5. Lower point of SPDT 1 is connected to the upper point SPDT Switch2.
6. Another wire which is taken through a P.V.C. pipe and middle point of SPDT switch 2 is
connected to one end of the lamp holder.
7. Another end of lamp holder is connected to neutral line.
8. Screw the accessories on the board and switch ON the supply.
9. Circuit is tested for all possible combination of switch positions.

TABULATION:
POSITION
CONDITION OF THE LAMP
SWITCH 1 SWITCH 2
1 2’ ON
1 2 OFF
1’ 2’ OFF
1’ 2 ON

RESULT:
Thus the staircase wiring is connected and tested.

You might also like