Scribd
Upload
32 views

Practical - 4 Aim - Port Security: Create A Simple Practice Lab As Shown

This document provides instructions for setting up port security on a switch. It instructs the user to configure a practice lab with a switch and PC, assign the PC an IP address of 10.0.0.10 with a subnet mask of 255.0.0.0, enable port security on the switch port connected to the PC, use the ping command to generate traffic, and run commands on the switch to test connectivity from the PC.

Uploaded by

sudhanshu
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
32 views

Practical - 4 Aim - Port Security: Create A Simple Practice Lab As Shown

This document provides instructions for setting up port security on a switch. It instructs the user to configure a practice lab with a switch and PC, assign the PC an IP address of 10.0.0.10 with a subnet mask of 255.0.0.0, enable port security on the switch port connected to the PC, use the ping command to generate traffic, and run commands on the switch to test connectivity from the PC.

Uploaded by

sudhanshu
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 4

Practical – 4

Aim – Port Security

Create a simple practice lab as shown

Assign the IP address (10.0.0.10) and subnet mask (255.0.0.0)


Configure port security
Use ping command to generate frames
Run following commands on switch and test connectivity from pc

You might also like