WIWeld21 Welding Defect Repair Rev 00
Uploaded by
Gautam KumarWIWeld21 Welding Defect Repair Rev 00
Uploaded by
Gautam KumarAnandji Haridas & Co. Pvt. Ltd.
Chakan
WI NO.WIWeld07 Rev 01 rev date 1st Dec 2019
WORK INSTRUCTIONS FOR welding Defect Repair
Purpose : To minimize the effect of the repair on the remaining portion of the weld
Scope:- Welded parts fails inspection, the welding inspector will review it in order to determine the extent
of damage that may be caused by repairing the weld and whether the welded parts can fulfill its function if the
defect is allowed to remain in place
Responsibility :Qualified welder & Welder QA
Record : welding Repaired register
• Assumption : the following conditions are necessary to considered in welding repair
• the condition of the base metal and weld
- the type of filler metal to be used in the repair
- the welding sequence
- any in-process inspection required during the repair
- tooling required for the repair
- the final weld’s mechanical properties
- Note Incomplete consideration of any of these factors may result in further rejection of the weld repair
and possible failure of the weld when placed into service or at customer end
Procedure :
1) Dimensional Repair;
Dimensional repairs are repairs that are required because the weld is too small for the
material and joint type.
These repairs involve the addition of material to increase weld size and are usually
necessary due to the insufficient addition of filler metal during the welding operation
Conditions that require dimensional repairs are to be considered as follows
Fig 1
Crown height is too low, Figure 1. A low crown does not provide adequate
reinforcement of the weld.
Repair this type of defect with stringer beads to minimize weld shrinkage.
Add only enough new filler metal to build the crown to height requirements.
Do not overweld.
B) Surfacing or overlay type weld height is too low, Fig 2
Figure 2. An Overlay Deposit With In sufficient Height
Surfacing or overlay that is not high enough reduces the durability and service life of
the surfaced material.
o Repair this type of defect with stringer beads to minimize dilution and
distortion.
C ) Fillet weld size is too small, Figure 3. Fillet weld length is satisfactory however the weld is concave
which reduces the actual fillet weld size
A small fillet weld does not provide adequate strength in the joint.
The weld is repaired by removing the inadequate weld
Rewelding to create the proper size fillet weld
C ) Surface defect Repairs
• Defects seen on the surface of the weld can extend deep into the weld.
• For this reason, the defect must be removed.
• After the defect has been removed,
• the area must be re-inspected before a repair can be attempted.
• Common defects and factors to be considered when repairing them are as follows:
Fig 4
• Longitudinal, transverse, or crater cracks, Figure 4
• . On steel and steel alloys, use a small grinding wheel like the one shown in Figure 5 to remove
cracks.
• Remove only the amount of metal required to eliminate the crack.
• Fig5
Rev Rev date Reason details Prepared Approved
no by By
0 02/05/2016 New released Gauttam Ulhas
kumar kavathekar
01 1st Dec Fillet weld Gauttam Ulhas
2019 added kumar kavathekar
