Scribd
Upload
142 views

Definitions:: Metamorphism and Tectonics

Uploaded by

saikumarreddy
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOC, PDF, TXT or read online on Scribd
142 views

Definitions:: Metamorphism and Tectonics

Uploaded by

saikumarreddy
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOC, PDF, TXT or read online on Scribd
You are on page 1/ 3

1

Metamorphism and Tectonics

Definitions:
Steady state geotherm: Is that curve defining the change in T as a function of depth in an
area that is not experiencing any tectonic activity such as a stable shield or continental
interior.

Transient geotherm: Is the geotherm in a tectonically active area, and will only prevail
for a limited time period that depends on the duration and type of this tectonic event.

Geothermal gradient: Is the slope of the geotherm at a particular time in the history of
the study area.

Metamorphic field gradient: Is a trajectory connecting the P-T conditions at the


maximum T calculated for each metamorphic zone. According to England and
Richardson (1977), the metamorphic field gradient has little physical meaning because
peak temperatures in each metamorphic zone were reached at different times during the
metamorphic history of the area.

An overview of metamorphism in relation to tectonic regimes:


The metamorphic facies series encountered in different tectonic regimes or settings can
be summarized as follows, and are shown schematically on Figs. 1 and 2:
(a) Ridges and rift valleys: characterized by high geothermal gradients ® contact and
ocean floor metamorphism.
(b) Areas of magmatic activity; volcanic - plutonic complexes: greenschists ®
amphibolites ® granulites.
(c) Areas of crustal thickening and mountain building: greenschists ® amphibolites ®
granulites and type B eclogites (particularly if there are magmatic intrusions).
(d) Subduction zones: Characterized by low geothermal gradients: zeolite ® pumpellyite-
actinolite facies /lawsonite albite facies ® blueschist facies ® type C eclogites.

A- Convergent Plate Boundaries:


I- Subduction Zone metamorphism:
Rocks of the subducted plate are usually metamorphosed following "clockwise" P-T
paths in which peak pressures are attained before peak temperatures. According to
tectonic setting, subduction is of two "types":
(a) B-type subduction: where the oceanic crust is subducted beneath a continental
or another oceanic plate. This type usually results in the formation of the "paired
metamorphic belts" of Miyashiro, with blueschists and eclogites in the subducted plate
close to the subduction thrust, and high T, low P amphibolite- and sandinite- facies rocks
on the overriding plate, commonly forming an island arc in the case of ocean - ocean
interaction (Figs. 3 and 4). Examples of this type include the Franciscan (with the Sierra
Nevada) in the western U.S.A., and the Sanbagawa (and Abukuma) belts in Japan.
(b) A-type subduction: where the continental crust "attempts" to become
subducted usually beneath another continental plate. Because of the low density of
2

continental material, it is generally more difficult to subduct compared to the oceanic


crust, and will have a tendency to "rebound" isostatically. Examples include the western
Alps (Dora Maira), the Tauern Window (Austrian Alps; Fig. 5), and Saih Hatat (Oman).

While discussing subduction zone metamorphism, it is appropriate to discuss some of the


problems associated with its rocks. The most important of these is the preservation of
blueschist facies mineral assemblages, and the uplift of blueschists.

Preservation of Blueschists:
 Most blueschists (and type C eclogites) are characterized by clockwise
P-T paths, and may therefore undergo heating and decompression during their
exhumation.
 If the geothermal gradient prevailing during exhumation is sufficiently
high, these rocks will pass through the greenschist, epidote amphibolite or
amphibolite facies upon exhumation.
 If exhumation rate is not rapid enough, these rocks will be overprinted
by these later assemblages to such an extent that they may not survive their trip to
the surface.
 Draper and Bone (1974) suggested that the preservation of blueschists
requires exhumation rates that cannot be accounted for by average erosional rates.
 Hairpin shaped paths and their significance  underthrusting and
refrigeration.

Models of blueschist and eclogite exhumation:


a) Platt's model: Platt (1987) suggested that blueschists and type C eclogites formed by
B-type subduction may be underplated (attached or accreted) to the overriding plate or
mantle wedge. Such process leads the accretionary wedge to become thicker and
tectonically unstable. This in turn leads to the development of normal faults along which
the high P/T rocks can make their way back to the surface fairly rapidly without being
significantly overprinted. This model is shown in Fig. 6. Note that a similar model can be
tailored to type A subduction zones.
b) Cloos's model: Cloos (1982) suggested that during B-type subduction, accretionary
wedge pelitic material moving down the subduction zone will tend to flow back upwards
by the forces of buoyancy, when it can then carry bits and pieces of the subducted slab
(now metamorphosed under blueschist and eclogite facies conditions; Fig. 7). This model
works only for tectonic mélanges, such as in the Franciscan.
c) Other models: Water melon seed model; delamination; …. etc.

Blueschists in time:
Most blueschists are Mesozoic in age, with some Paleozoic examples, and only a handful
of Precambrian ones. Could this be due to Plate tectonics not operating during the
Precambrian the way we think it does today? Or is it a function of differences in
geotherms prevailing at those times? Post-Eocene blueschists are also very rare or non-
existent. Can you think of a reason?

II- Thrusting and continent - continent collision:


3

Not all areas of continent – continent collision are characterized by high P/T
metamorphism; many were found to belong to Miyashiro’s high P, intermediate facies
series; whereas others are associated with so much magmatic activity that they may be
considered to belong to the “regional – contact” type of metamorphism of Spear (1993).
Examples of these two cases include:
1- The Himalayas (which have an inverted metamorphic gradient in which the Sill
zone overlies the Ky zone, which in turn overlies the Gt and Bt zones (Fig. 8).
Several models have been proposed to explain this inverted sequence and the P-T
paths obtained. These are shown schematically in Figs. 9 and 10.
2- New England: The northern Appalachians are characterized by a complex
Polymetamorphic history. The main event seems to have been Acadian, in which
a continental fragment collided with N. America resulting in partial melting and
the development of numerous igneous intrusions. Nappes containing sheet – like
igneous intrusions were emplaced onto colder sheets. The overthrust nappes
therefore had counterclockwise P-T paths, whereas the lower nappes were
characterized by periods of isobaric heating followed by near isothermal loading
(Fig. 11).

III- Metamorphism associated with ophiolite emplacement:


1- Subophiolitic metamorphic aureoles or soles and inverted metamorphic gradients.
2- Burial type metamorphism with a high P/T field gradient
3- Subduction zone metamorphism

B- Stable continental interiors and deep sedimentary basins:


These are characterized by burial metamorphism with clockwise P-T paths, and peak T in
the greenschist to epidote amphibolite facies.

C- Divergent Plate Boundaries:


1- Ocean Floor Metamorphism:
2- Continental rifts: In such settings, it is very common to find “metamorphic core
complexes”, defined as areas that are topographically high and that consist of igneous
and metamorphic rocks that display anomalous deformation and metamorphism
relative to the surrounding rocks. These complexes are structurally overlain by
normally faulted sedimentary rocks. The boundary between the complexes and the
sedimentary rocks is a low angle normal fault known as a “decollement”. Rocks of the
metamorphic core complex are characterized by clockwise P-T paths of evolution,
with segments of isothermal decompression, marking their rapid exhumation along
these decollements. Examples include several areas in the Basin and Range province,
and the Cordillera Darwin in Chile (Fig. 12).

Conservative Plate Boundaries:


1- Cataclasis and Mylonitization
2- Serpentinite diapirs and associated metasomatism.

You might also like