Scribd
Upload
138 views2 pages

G70 Finishing Cycle (Group 00) - Lathe: Haas Technical Documentation

Uploaded by

Claudio Salcedo Coaquira
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
138 views2 pages

G70 Finishing Cycle (Group 00) - Lathe: Haas Technical Documentation

Uploaded by

Claudio Salcedo Coaquira
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 2

Haas Technical Documentation

G70 Finishing Cycle (Group 00) - Lathe Scan code to get


the latest version
of this document

Translation
Available

G70 Finishing Cycle (Group 00)

Copyright 2018 by Haas Automation, Inc. No unauthorized reproduction | Last Published On September 06, 2018 1/2
The G70 Finishing Cycle can be used to finish cut paths that are rough cut with stock removal cycles such as G71,
G72 and G73.

P - Starting Block number of routine to execute


Q - Ending Block number of routine to execute

G18 Z-X plane must be active

G70 Finishing Cycle: [P] Starting block, [Q] Ending Block.

G71 P10 Q50 F.012 (rough out N10 to N50 the path) ;

N10 ;

F0.014 ;

... ;

N50 ;

... ;

G70 P10 Q50 (finish path defined by N10 to N50) ;

The G70 cycle is similar to a local subprogram call. However, the G70 requires that a beginning block number (P code)
and an ending block number (Q code) be specified.

The G70 cycle is usually used after a G71, G72 or G73 has been performed using the blocks specified by P and Q.
Any F, S, or T codes with the PQ block are effective. After execution of the Q block, a rapid ( G00) is executed
returning the machine to the start position that was saved before the starting of the G70. The program then returns to
the block following the G70 call. A subprogram in the PQ sequence is acceptable providing that the subprogram does
not contain a block with an N code matching the Q specified by the G70 call. This feature is not compatible with
FANUC or YASNAC controls.

Copyright 2018 by Haas Automation, Inc. No unauthorized reproduction | Last Published On September 06, 2018 2/2

You might also like