Scribd
Upload
47 views

Assi No 8

This document provides instructions for Assignment 08 which is due before the next lecture. It contains 3 questions - the first asks students to determine the input capacitance and saturation level for a given network diagram and comment on these values. The second question asks students to explain what a load line is and describe load line analysis for a BJT in a fixed DC bias configuration. The third question provides a load line diagram and defined operating point, asking students to determine the required power supply voltage, collector resistor value, and base resistor value for a fixed bias configuration.

Uploaded by

Oxman Bhatti
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
47 views

Assi No 8

This document provides instructions for Assignment 08 which is due before the next lecture. It contains 3 questions - the first asks students to determine the input capacitance and saturation level for a given network diagram and comment on these values. The second question asks students to explain what a load line is and describe load line analysis for a BJT in a fixed DC bias configuration. The third question provides a load line diagram and defined operating point, asking students to determine the required power supply voltage, collector resistor value, and base resistor value for a fixed bias configuration.

Uploaded by

Oxman Bhatti
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
You are on page 1/ 2

Assignment 08 (CLO2)

NOTE:
 Submit before the start of next lecture
 Upload on your student portal in handwritten form.

 Q.1. Determine ICQ and the saturation


level for the network of Fig. Also make
comments on ICQ and ICsat

Q.2. What is load-line and explain the load


line analysis for fixed DC bias configuration
of BJT.
Q.3. Given the load line of Fig. and the
defined Q-point, determine the required
values of VCC, RC, and RB for a fixed-bias
configuration.

You might also like