Scribd
Upload
2K views2 pages

YET402PC: Two-Circuit Wireless Smart Receiving Controller

The document summarizes the technical specifications and features of a two-circuit wireless smart receiving controller. It can be matched with various wireless receivers and remote controls using fixed codes, learning codes, or rolling codes. The controller has two learning buttons that are used to learn remote control buttons for each of the two relays. Pressing a learning button for over 8 seconds will clear the memory for that button/relay.

Uploaded by

Vrhovac Radenko
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
2K views2 pages

YET402PC: Two-Circuit Wireless Smart Receiving Controller

The document summarizes the technical specifications and features of a two-circuit wireless smart receiving controller. It can be matched with various wireless receivers and remote controls using fixed codes, learning codes, or rolling codes. The controller has two learning buttons that are used to learn remote control buttons for each of the two relays. Pressing a learning button for over 8 seconds will clear the memory for that button/relay.

Uploaded by

Vrhovac Radenko
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 2

YET402PC-V2.

0
Two-circuit Wireless Smart Receiving Controller
I. Main technical indexes

Working voltage:DC9V-DC24V Static working current:≤7mA


Working temperature:-40℃- +80℃ Receiving sensitivity:≥ -112dBm
Working frequency:315MHz、433MHz(Optional) Contact current:≤ 3A
Remote controlcapacity: 400 Size: 90x60x28.5mm

II. Features of the controller

The product is a general smart receiver and it can be matched with the majority of the
wireless receiver in the market, including fixed code (2262, 2260, 2264, 5326, M1E,
M5E etc.), learning code(1527, 2240, 6P20B, 6P20D etc.), rolling code(HCS301,
HCS300,HCS200,HCS201,HSC100,HCS101 etc.) and a part of customized remote
controller(CAME, NICE FLro etc.).

III. Methods and steps for learning and clearing code


IV.Wiring Diagram
Press the learning button on the receiver and then release it after LED lamp is lit and
the receiver enters into the learning state (At this moment, L E D lamp is off). After that,
press the remote control button (more than 2s) that is required to control the controller.
If LED lamp on the receiver flashes for 2 times and then is off, it indicates that the learning
is success. The remote controller, studied by the learning button 1 on the controller,
corresponds to the relay 1; likewise , the learning button 2 corresponds to the relay 2.
Once the learning starts, only inching is available.
If the remote control is lost and it intends to fail the entire remote controller, long press
the learning button 1 or the learning button 2 (more than 8S) until LED lamp is off and
then the receiver will automatically clear the memory contents. If it is to be reused,
just study it once again.
Remarks: Please start copy the code 5s later when memory cleared,
not continuous operation

www.szyet.com
IV.Wiring Diagram

Study key1 Study key2

Singer Chip
micro computer
GND:Powersupply
High frequency receiving module V+：Power positive
Ch2：relay 2 output
A B Study LED Ch1：relay 1 output
Relay Relay ANT：High frequency receiving
Power LED
module antenna

ANT Ch1 Ch2 V+ GND

You might also like