Experiment No: 15 Experiment Name:: JK Flip Flop To D Flip Flop
Uploaded by
Mohayminul Al-HamimExperiment No: 15 Experiment Name:: JK Flip Flop To D Flip Flop
Uploaded by
Mohayminul Al-HamimName: Mohayminul Al-Hamim
ID: 153402032
Experiment No: 15
Experiment Name: Construction of a JK Flip Flop to D Flip Flop and D flip flop to
JK flip flop
Objective:
To observe the conversion between different types of flip flops.
To implement the obtained equation and observe the outputs.
To verify the outputs using the truth table.
Required Apparatus:
Logisim untitled app.
AND gates IC types 7408 Quadruple 2 input.
NOT gates IC types7404 Quadruple.
OR gates IC types 7432 Quadruple 2 input
Input and output gates.
D and JK flip flops
Theory:
JK Flip Flop to D Flip Flop:
D is the external input and J and K are the actual inputs of the flip flop. D and
combinations. J and K are expressed in terms of D and Qt. The four-combination
conversion table, the K-maps for J and K in terms of D and Qt, and the logic diagram
showing the conversion from JK to D are given below.
Conversion Table:
D Q(t) Q (t-1) J K
0 0 0 0 X
0 0 1 X 1
1 1 0 1 X
1 1 1 X 0
1
Name: Mohayminul Al-Hamim
ID: 153402032
Fig: JK Flip Flop to D Flip Flop Diagram
D Flip Flop to JK Flip Flop:
In this conversion, D is the actual input to the flip flop and J and K are the external
inputs. J, K and Qt make eight possible combinations, as shown in the conversion table
below. D is expressed in terms of J, K and Qt. The conversion table, the K-map for D in
terms of J, K and Qt and the logic diagram showing the conversion from D to JK are
given in the figure below.
Conversion Table:
J K Q(t) Q(t-1) D
0 0 0 0 0
0 0 1 1 1
0 1 0 0 0
0 1 0 1 0
1 0 1 0 1
1 0 1 1 1
1 1 1 0 1
1 1 0 1 0
2
Name: Mohayminul Al-Hamim
ID: 153402032
Fig: Circuit diagram for D flip flop to JK flip flop
Circuit Diagram Simulation:
Fig: JK Flip Flop to D Flip
3
Name: Mohayminul Al-Hamim
ID: 153402032
Fig: D flip flop to JK flip flop
Procedure:
At first, in the Simulator Application the logic gates and other components should be
placed.
The logic gates and other components should be connected with connectors.
Finally, using the Toggle Switches the outputs can be observed and compared with the
truth table in the monitor.
Discussion:
Connectors should be connected properly with the proper logic gates and other
components.
The hand cursor should be disabled to receive uninterrupted assistance from the
simulator application.
