Scribd
Upload
223 views

GMT200 Quick Start

The document provides instructions for basic operation of the GMT200 device, including: 1) Installing required drivers and connecting the GMT200 to a computer via USB cable. 2) Using the PC management tool to configure reporting parameters such as SMS or TCP mode, and inputting server details. 3) Configuring scheduled position reports and geo-fence rules before the GMT200 can begin basic tracking functions.

Uploaded by

MiChael Tibacuy
Copyright
© © All Rights Reserved
Available Formats
Download as PDF, TXT or read online on Scribd
223 views

GMT200 Quick Start

The document provides instructions for basic operation of the GMT200 device, including: 1) Installing required drivers and connecting the GMT200 to a computer via USB cable. 2) Using the PC management tool to configure reporting parameters such as SMS or TCP mode, and inputting server details. 3) Configuring scheduled position reports and geo-fence rules before the GMT200 can begin basic tracking functions.

Uploaded by

MiChael Tibacuy
Copyright
© © All Rights Reserved
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 2

GMT200 Quick Start

Page 1 : Basic Operation

Check Parts List Install SIM Card


Remove the cover.

The USB Data_Cable_M is


not in the delivery list.

k
Please contact your ven-
dor for it.

li n l
Reset key
Reset the device

e c t ia
u
Q fid e n
Find “PL2303_Prolific_DriverInstaller_vXXX.zip” in
develop suit and install the driver for PL2303. If
you have already installed it please go to Step 6.
Connect GMT200 to computer by USB
Data_Cable_M.

o n
C
To mini USB

To computer

Find “Queclink GMT200 Manage Tool Vx.xx.exe” in develop


suit and run it to configure the running parameters of
GMT200.
Page 2 : PC Manage Tool Quick Start
If you want to test the GMT200 by SMS then set
“Report Mode” to “SMS” and input the phone num-
ber which you want to receive the SMS from
Run manage tool. Select correct Com port and input GMT200. After that you can go to Step 6.
default password “gmt200”. Then press OK.
Otherwise please go to Step 3

Set “Report Mode” to “TCP Short Connection”. input

k
the IP address and port number of the backend
server. Please make sure the IP address can be ac-
cessed by internet and the data sends to this address

li n l
Please contact your SIM card provider and get the
APN information for GPRS. Input it in GTBSI set-
ting.

e c t ia
u
Q fid e n
Press the “Send” button and update the
parameters of GMT200. Then the GMT200
can report information to your backend
Set the parameters of scheduled fixed timing
report so that the GMT200 will report it’s posi-
tion to backend server period periodically. Press

n
server or SMS receiver. “Send” button to update the parameters.
Note: These commands can also be sent to
GMT200 by SMS. Follow screen shot shows how to configure the

C o
Command has been accepted when you see the

The following screen shot shows how to create a


Geo-Fence rule. Press “Send” button to update
the parameters. After these steps. GMT200 will have
some basic tracking functions like
scheduled timing report and Geo-Fence.
For other advanced functions of
GMT200 please refer to “GMT200
@Tracker Air Interface Protocol” or visit
our website.

http://www.queclink.com
[email protected]

You might also like