Scribd
Upload
121 views

Set-Up Approval Report-XYZ

1. This is a first piece inspection report for an upper separator part from Swaran Auto Systems. 2. It provides specifications for 5 dimensions and appearances of the part including diameter, radius, dimple height, and checks for burrs, dents or other defects. 3. The report finds the part meets all specified dimensions and appearance standards and approves the part.

Uploaded by

swaran autoqa
Copyright
© © All Rights Reserved
Available Formats
Download as XLSX, PDF, TXT or read online on Scribd
121 views

Set-Up Approval Report-XYZ

1. This is a first piece inspection report for an upper separator part from Swaran Auto Systems. 2. It provides specifications for 5 dimensions and appearances of the part including diameter, radius, dimple height, and checks for burrs, dents or other defects. 3. The report finds the part meets all specified dimensions and appearance standards and approves the part.

Uploaded by

swaran autoqa
Copyright
© © All Rights Reserved
Available Formats
Download as XLSX, PDF, TXT or read online on Scribd
You are on page 1/ 1

SHEET:-

SWARAN AUTO SYSTEM


( A UNIT OF SWARAN ENTERPRISES)

FIRST PCS INSPECTION REPORT(SET-UP APPROVAL REPORT) Doc No. SAS/QA/F-10

Part Name SEPARATOR UPPER M/c Name Rev.No/Date 0.00/1.4.2018


Part Drg .No. 17505-AAE-1000-22 M/c No. Insp.Date
Drg.Rev.No 00 Tool/Die Re-Insp.Date

ACTUAL ∆-Temp.Dev.
MFG. MODE OF
S.NO DESCRIPTION SPECIFIED DIMENSION *-Need Rect.
PROCESS INSPECTION 1 2 3 4 5 o-OK
1 Diameter DVC 39.80±0.50(39.30~40.30)

2 Radius RG R-5.50

3 Dimple Height RG 3.00±0.20(2.80~3.20)


Punching,E
mbossing &
*Part free from burr,dent,
scretch,tool mark ,bend
4 Appearance Visually
etc.Ovality & Burr in punching
hole,dimple shift not allowed.

SH stamping should be clearly


5 Appearance Visually
visible

DIMENSIONAL APPEARANCE MATERIAL FITMENT


Remarks:- DECISION

OK

NG

INSPECTED BY VERIFIED BY APPROVED BY

You might also like