Note: Answer of highlighted questions are not sure.

Irrigation, Fluid Mechanics & Hydraulics:

1. When drain can not pass clearly under canal, then the structure is called syphon
aqueduct.
2. Equation of continuity is based on law of conservation of mass.
3. Area of land irrigated by unit discharge is duty.
4. When the river starts taking silt from downstream side, it is called retrogration.
5. When reservoir is full, then compression is on toe side.
6. Jinnah barrage is located at Kalabagh, Indus.
7. Mahmand Dam is concrete faced rock fill dam with capacity 800 MW.
8. If RL of a point is 500 m and slope is 1 in 1000, then the RL of a point 2.5 km on
d/s side is 497.5 m.
9. Structure built to stop the water temporarily for construction is coffer dam.
10. Rating curve is relation between flow vs stage.
11. Wall constructed at outlet of canal for diversions is wing wall.
12. In canal lining, joints provided for creep, shrienkage etc are contraction joints.
13. When pressure energy of water is converted to kinetic energy and it strikes the
wheel of turbine with high velocity, then the name of turbine is Pelton Wheel.
14. Separate availability of spillway site, favors the embankment dam.
15. Computerized analysis and forecasting of floods etc is done by HEC-RAS.
16. Reynolds number at which flow changes from laminar to turbulent is 2000.
17. If excavation of soil does not effect soil’s angle of repose then type of excavation
used is shovel.
18. Load caused by flow of fluid is called sediment load.
19. Flood in the highly populated area is called urban flooding.
20. Power supplied by pump is γQH.
21. When the water is drawn from well then cone of depression is formed.
22. Which of the following is not the oceanic land form: waterfall.
Seismic Design of Buildings:
23. When the plan is irregular, then the building will twist under EQ force.
24. By increasing mass of building, its Time Period increases and its frequency
decreases.
25. By increasing weight of building base shear is increased.
26. In dual system, Shear is resisted by parallel walls & beams.
27. Striking of building with the nearby building in EQ is called pounding.
28. Graph of peak displacement and time in EQ is called time history.
Structural Analysis & Design:
29. Lacing does not carry forces and it only resists buckling.
30. In beams, flexural stress is maximum at extreme fibers and shear stress is
maximum at center.
31. In 3D system, number of equilibrium equations is 6.
32. In 2D frame, number of restraints is 3.
33. Number of degree of freedom in pin support is 1 and in fixed support is 0.
34. Poisson’s effect comes into action in case of axial.
35. Yield strength of A36 steel is 250 MPa.
36. Sequence of load transfer in steel bridge is deck slab, stringers, cross-beam &
truss.
37. Material having direction-dependent properties is anisotropic and wood is
orthotropic material.
38. When principle stress is 10, then shear stress at principal plane is Nill.
39. Steel bar fails at strain of 12.
40. Stiffeners provided at points of application of concentrated loads and end
reactions to prevent compression in web are bearing stiffeners.
Concrete Technology:
41. Durability of concrete is measured by soundness test.
42. Dimensions of tiles are 50 cm X 50 cm and area of floor is 12 m X 6 m, then
number of tiles are 288.
43. Minimum steel ratio in slab is 0.0018 and in column is 1%.
44. 75 % of load is taken by column strip.
45. In case of slab with no beams, 40 % of negative steel is taken as column strip
reinforcement.
46. Minimum strength of concrete and tendons in prestress concrete is 10-20 ksi &
____.
47. ASTM code for compressive strength of concrete cube is C39.
48. fc’ is defined as 28 days cylinder strength.
49. Maximum moment occurs in column strip.
50. Strength of concrete will be more in case of gamma value of 0.9 is more than 0.6.
51. Main cementing material in concrete is C3S and SCM is used because of
pozzolanic properties.
52. Amount of water in concrete mix design is based on slump and maximum
aggregate size.
Management:
53. ES = 2, EF = 12, LS = 9, LF = 19, then activity is not on critical path.
54. Evaluation of product is done on planning phase and consultant is responsible
for it.
55. Deliverable are output of project scope.
56. Public Private Partnership is done between private agency and government
agency.
Geo Technical Engineering:
57. Base failure occurs when foundation soil is weaker than embankment.
58. Which type of soil is expansive according to USCS is SM.
59. When water rises from depth to soil surface, then bearing capacity decreases to
50 %.
60. Depth of foundation is decided on the basis of Shear.
61. Plate load test is done for determining BC, settlement, Modulus of subgrade
reaction, all of these.
62. Slab on grade is designed for temperature and shrienkage.
63. In case of failure in two parallel walls, the shoring provided is flying.
64. For multi-column footing, load resultant is applied at centroid and pressure is
uniform.
Surveying:
65. When magnetic bearing of moon at noon is N20E then magnetic declination is
20W.
66. Route survey is done for (A) Allignment etc etc.
67. Shifting of large area of land on paper is called plan.
68. Curve between two tangent having variable radius is compound curve.
Highway:
69. Load on rare wheel of truck in HL-93 loading is 145 kN.
70. 5 % slope is suitable for speed of 60 mph.
71. Limit of super elevation for broad gauge is 75 mm.
72. Repairing of airoplanes is done at hangers.
73. Self cleansing velocity in case of partially combined sewer is 0.7 m/s.
74. Best roads in history were built by Romans.
Public Health:
75. In underground water tank, when the tension is on soil side, the tank will be
empty.
76. Change of colour of water is called turbidity.
77. Outfall sewer collects water from all disposal points.
78. Pump is designed for maximum flow.
79. Flow in water supply pipes and sewer pipes is Pressure, gravity.
80. Amount of TDS in water is 1000 mg/l.
General Knowledge:
81. Imran Khan is 22nd PM of Pakistan.
82. Obama was 44th president of USA.
83. Study of Fruits and Seeds is called Carpology.
84. Study of fossils is called Paleontology.
85. Ch. Muhammad Ali was the PM at the time of 1st constitution.
86. AL swept the election of 1970.
87. Thimphu is the city of Bhutan.
88. Capital of Taiwan is Taipei.
89. Odd one from the numbers was 28.
90. 8 sided diagram is called Octagon.
91. I worked at Lahore 10 years ago.
92. Well-to-do means rich.
93. Samina Baig is Mountaineering.
94. Length of Penality area in football is 16.5.
95. Bait-al-Maqdas is also called Masjid-e-Aqsa.
96. Hazrat Suleman had control on jinns.
97. VGA means Video Graphic Array.
98. “Kapas ka Phool” is written by Ahmad Nadeem Qasmi.
99. Ghareeb nay rozay rakhay tu din lambay ho gaye.