CIGRE Studyy Committee D1

การไฟฟ้าฝ่ายผลิตแห่งประเทศไทย
ผลิตไฟฟ้ าเพือ
่ ความสุขของคนไทย
 Contents

• SC D1 Mission and Scope

• Strategic Plan of SC D1
• SC D1 Organization Chart
• Published Technical Brochures of SC 15 & SC D1
• Sample Contents of Technical Brochures 494, 502 and 506

2
 SC D1 Mission and Scope
SC D1 Materials and Emerging Test Techniques, Mission and Scope

MISSION
• To facilitate and promote the progress of engineering and the international exchange of
information and knowledge in the field of materials test technologies and diagnostic tools for
electric power systems
• To improve the information and knowledge by synthesising state-of-the-art practices and
developing recommendations and to identify, investigates, monitor and report upon new or
novel materials, emerging technologies and diagnosis test techniques which have the
potential for application within electric power systems but where the precise nature of such
use is unclear or where technological obscures a clear route to implementation

3
 SC D1 Mission and Scope (cont.)
MISSION (cont.)
• To make recommendations to relevant study committees for activity regarding new or novel
materials, emerging test technologies and diagnosis techniques and concepts which have
reached, or are about to reach, a level of maturity where experimental developments or
prototypes can be applied to electrical power systems or where a clear route to
implementation can be foreseen
• To investigate, monitor and report upon the use of new or novel materials, test technologies
and diagnosis
g concepts
p that are sufficientlyy mature for use within electric ppower systems
y but
which can be commonly applied across several study committee areas
• To support other study committees in their analysis of recently introduced and developing
materials, tests techniques and concepts where relevant expertise exists within D1

4
 SC D1 Mission and Scope (cont.)
SCOPE
The activities of CIGRE Study Committee D1 concern the following main
directions:
• new and existing materials for electrotechnology,
• emerging test technologies and diagnosis techniques,
• support of other study committees in their analysis of recently
introduced and developing materials, emerging test technologies and
diagnosis
i i techniques
i
Said activities are focused mainly on transmission and distribution but emerging
generation technologies will also be specifically considered.
considered

5
 SC D1 Mission and Scope (cont.)
SCOPE (Cont.)

Within this scope, the work of the Study Committee is principally scientific in
nature and has as its main aim the provision of timely information on new developments and
trends in the field of materials and emerging test technologies to other CIGRE Study
C itt
Committees.
Through its work the Study Committee strives to keep CIGRE fully aware of the
evolution of materials and emerging testing technologies relevant to its activities.
activities
Where the scope of SC D1 work overlaps that of other study committees, we will
strive for good communication and co co-operation,
operation, the co
co-ordination
ordination of all activities, and,
where appropriate, joint activities. Such interactions will extend to all study committees.

6
 Strategic Plan of SC D1
Major changes to previous plan

• Scope of SC D1 extended to all kind of materials for electrotechnology,

i.e. electrical insulating and electrical conducting materials (already
effective since 2008)
• Scope of SC D1 to be extended to electrical insulation systems (EIS)
[Electrical insulation system (EIS): Insulating structure containing one or more electrical
insulating materials (EIMs) together with associated conducting parts employed in an
electrotechnical device (IEC 60085)]

7
 Strategic Plan of SC D1 (cont.)
New and major directions of activities
Materials for electrotechnology and electrical insulation systems (EIS)
– Dielectric, conduction and oxidation performance of insulating liquids
– Functional and nanomaterials for electric power industry
– Material properties for HVDC application
• Emerging test and diagnosis techniques
– Test techniques for UHV equipment
– Test techniques for HTS power applications
– Evaluation of conventional and unconventional measuring procedures

8
 Strategic Plan of SC D1 (cont.)
New and major directions of activities (cont.)

• Support of other study committees in their analysis of recently introduced

and developing materials, emerging test and diagnosis techniques
– Continued care of customer relations
– Intensification of Workshop/Tutorial activities

9
3
 Published Technical Brochures of SC 15 & SC D1
No. Title Published
506 G Insulated
Gas I l t d Systems
S t for f HVDC:
HVDC DC stress
t att DC andd AC systems
t 08 2012
08-2012

502 High-Voltage On-Site Testing with Partial Discharge Measurment 06-2012

501 Basic principles to determine methane in cross-linked in solid extruded insulation of MV and HV cables 06-2012

494 Furanic compounds for diagnosis 03-2012

493 Non-destructive water-tree detection in XLPE cable insulation 03-2012

489 Requirements on Testing Flammability of Polymeric Materials for Outdoor Insulation 02-2012

488 Resistance to Weathering and UV Radiation of Polymeric Materials for Outdoor Insulation 02-2012

478 Important Material Properties of RTV Silicone Rubber Insulator Coatings 10-2011

11
Published Technical Brochures of SC 15 & SC D1 (cont.)
No. Title Published
451 Pl
Polymer N
Nanocomposites:
it FFundamentals
d t l andd possible
ibl AApplications
li ti tto PPower SSectors
t 02 2011
02-2011

444 Guidelines forUnconventional Partial Discharge Measurements 10-2010

443 DGA in Non-Mineral Oils and Load Tap Changers and Improved DGA Diagnosis Criteria 10-2010

Evaluation of Dynamic Hydrophobicity Properties of Polymeric Materials for Non-Ceramic Outdoor

442 10 2010
10-2010
Insulation: Retention and Transfer of Hydrophobicity

420 Generic Guidelines for Life Time Condition Assessment of Hv Assets and Related Knowledge Rules 06-2010

Status of Development and Field Test Experience With High-Temperature Superconducting Power
418 06-2010
Equipment

414 Dielectric Response Diagnoses For Transformer Windings 04-2010

12
Published Technical Brochures of SC 15 & SC D1 (cont.)
No. Title Published
413 I l ti Oil RRegeneration
Insulating ti andd Dehalogenation
Dhl ti 04 2010
04-2010

409 Report on Gas Monitors for Oil-Filled Electrical Equipment 02-2010

366 Guide for Partial Discharge Measurements in Compliance to IEC 60270 12-2008

323 Aging
g g of Cellulose in Mineral-Oil Insulated Transformers 10-2007

297 Practical Aspects of the Detection and Location of Partial Discharges in Power Cables 06-2006

292 Data Mining Techniques and Applications in the Power Transmission Field 04-2006

288 Space Charge Measurement in Dielectrics and Insulating Materials 02-2006

13
Published Technical Brochures of SC 15 & SC D1 (cont.)
No. Title Published
Instrumentation and Measurements for in-service Monitoringg of
286 12-2005
High Voltage Insulation

260 N2/SF6 Mixtures for Gas Insulated Systems 10-2004

255 Material Properties for Non-ceramic Outdoor Insulation 08-2004

254 Dielectric Response Methods for Diagnostics of Power Transformers 2002

228 Service Aged Insulation Guidelines on Managing the Aging Process 06-2003

226 Knowledge Rules for Partial Discharge Diagnosis in Service 04-2003

225 Electrical Power Systems 2020 08-2002

08 2002

14
Published Technical Brochures of SC 15 & SC D1 (cont.)
No. Title Published
224 Emerging Technologies and Material Challenges 08-2002

15
Sample Content of Technical Brochure 494

Figure 18: Aged insulation compared to a new transformer winding.

16
 Sample Content of Technical Brochure 494 (cont.)

Figure 25: 2-FAL detected in the oil (mg/kg) versus degradation factor from scrapped transformers.

17
 Sample
p Content of Technical Brochure 502

Figure 1.4: Examples for HV tests with PD measurement

400 kV GIS by ACRF (frequency tuned resonant circuit) test system of modular
reactors via bushing

18
Sample
p Content of Technical Brochure 502 ((cont.))

Figure 1.4: Examples for HV tests with PD measurement

400 kV GIS by ACRF test system with directly flanged reactor

19
Sample
p Content of Technical Brochure 502 ((cont.))

Figure 1.4: Examples for HV tests with PD measurement

150 kV HV cable system by DAC test system (damped alternating voltages)

20
Sample
p Content of Technical Brochure 502 ((cont.))

Figure 1.4: Examples for HV tests with PD measurement

400 kV/433 MVA power transformer by static frequency converter

21
Sample
p Content of Technical Brochure 506

Fig. 7.1: Long-term test for one year in the Yamazaki Experiment Center

22
23