Scribd
Upload
64 views

7.0 Hydrograph

- A hydrograph plots discharge over time and has three regions: rising limb, crest, and falling limb. The shape depends on rainfall characteristics and the watershed. - Factors like rainfall intensity, distribution, duration, watershed size, shape, land use, etc. affect the hydrograph shape. Steeper watersheds have sharper peaks while flatter areas have broader hydrographs. - A unit hydrograph represents the runoff from 1 unit of effective rainfall uniformly distributed over the watershed for a specified duration. It is used to develop hydrographs for other rainfall events in that watershed.

Uploaded by

Siddhartha Saha
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
64 views

7.0 Hydrograph

- A hydrograph plots discharge over time and has three regions: rising limb, crest, and falling limb. The shape depends on rainfall characteristics and the watershed. - Factors like rainfall intensity, distribution, duration, watershed size, shape, land use, etc. affect the hydrograph shape. Steeper watersheds have sharper peaks while flatter areas have broader hydrographs. - A unit hydrograph represents the runoff from 1 unit of effective rainfall uniformly distributed over the watershed for a specified duration. It is used to develop hydrographs for other rainfall events in that watershed.

Uploaded by

Siddhartha Saha
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 31

Pailan College of Management & Technology

Civil Engineering Department

Hydrograph
Tapas Pattanayek
• Plot of discharge against time
• Has three regions: rising limb, crest segment
and falling limb
• Nature of hydrograph depend on rainfall and
watershed characters.
• Isolated storm results single peak hydrograph
and complex storm yields multiple peak
hydrograph.
Hydrograph
• Rising limb
– Ascending portion representing rising discharge
due to gradual increase in flow in stream
– Slope depend on storm and basin characteristics
• Crest Segment
– Inflection point on rising limb to falling limb
– Indicate the peak flow
– Controlled by storm and watershed characteristics
– Multiple peaks – due to occurrence of two or
more storms of different intensities in a closer
interval
• Falling limb (recession limb)
– From point of inflection at the end of crest
segment to base flow.
– Inflection point indicate the time at which rainfall
stopped
– Shape independent on storm characteristics but
dependant on watershed characteristics
Factors affecting shape of hydrograph
• Climatic factors
– Form of precipitation
• Rainfall and snow fall – rainfall tends to produce runoff
rapidly generating hydrograph with high peak and
narrow base
– Rainfall Intensity
• Affect volume of runoff , occurrence of peak flow,
duration of surface flow
• Higher the intensity quicker the peak flow and conical
hydrograph
– Duration of rainfall
• Longer the duration more the volume
• Longer duration, peak flow occur after longer time and
hydrograph is flatter with broad base
– Distribution of rainfall
• When heavy rain occur near outlet
– Peak flow occur quickly
• When heavy rain occur in upper areas
– Peak flow occur after few hours
– Lower peak and broad base (more time taken for flow to
reach outlet)
– Direction of storm movement
• Affects amount of peak flow and surface flow duration
• Upward direction – lower peak and broad base
• Downward direction – sharp peak and narrow base
Distribution of
rainfall and
hydrograph

Hydrograph affected by movement of rainfall


• Physiographic factors - characteristics of
watershed
– Shape of basin
• Affects the shape of hydrograph affecting time of
concentration
• Broad shaped – peak flow occur soon because of less
time of concentration, narrow hydrograph with high
peak
• Fan shaped – peak flow occur at longer time interval
because of longer time of concentration, broad base
lower peak hydrograph
Effect on Hydrograph by Shape of catchment
– Size of basin
• Small basin – flow dominated by overland flow that
joins channel quickly, peak flow occur quickly
– Stream slope
• More the stream slope higher the slope of recession
limb, reduce base width of hydrograph
• Small slope make recession limb flatter, base width
wider
– Nature of valley
• Greater valley slope higher the slope of recession limb
– Drainage density
• Higher the drainage density, quicker the peak flow,
recession limb is steeper with narrow hydrograph
• Lesser the drainage density, slow moving rising limb
and wide base width
– Landuse
• Vegetation increases loss of water
• Higher the vegetation density, lesser the peak flow
– Surface depression
• Presence of ponds, rills etc. delay and modify flow
pattern
• Decreases peak flow and wide base width
Base flow separation
• Surface runoff hydrograph derived by
separating base flow from hydrograph

• Straight line method


– Join the starting and end points of surface runoff
by straight line
– Area under the straight line is base flow
• Fixed base method
– Draw straight line from end point of surface runoff
on rising limb to a point obtained by N = 0.83 A0.2
where A is area of watershed in km2 and N is days
• Variable slope method
– Base flow before concentration with surface
runoff is extended till it reaches the perpendicular
line drawn from peak
– Intersection point is extended to a point given by
N = 0.83 A0.2 on recession limb
• Base flow recession curve method
– Extend base flow recession curve backward till it
intersects perpendicular line drawn from
inflection point on recession limb
– Join surface runoff concentration point on rising
limb to intersection point
Effective rainfall hyetograph
• Effective rainfall – Part of precipitation that
entirely contribute to the formation of direct
runoff
• ERH shows effective rainfall and initial loss
• ERH provide information on
– Effective rainfall depth and duration
– Direct runoff volume
– Amount of initial loss
• ERH can be used to determine effective
rainfall
n
ER   I i t
i 1
ER – effective rainfall depth (cm or mm)
Ii = Rainfall intensity at time i (cm/h or mm/h)
Δt = time interval

Volume of runoff = ER x A (Unit conversion needs to


be done)

Initial Loss = Area of hyetograph – Area of ERH


Direct Runoff Hydrograph
• Plot of direct runoff and time
• Area of hydrograph gives the volume of direct
runoff which is response to effective rainfall
• No base flow included to direct runoff
hydrograph

• Relationship between DRH and ERH


– Both shows the same total quantity of direct
runoff but in different units
AERH x AW  ADRH
ADRH
AERH  AERH – Area of ERH
AW Aw – Area of watershed
ADRH – Area of DRH
ADRH
ER 
AW
Computation of Direct Runoff from
DRH
• Separate base flow and get the DRH
• For different time intervals calculate the area
under the curve

Volume of Direct Runoff  A1  A2  A3  .... An

1    Q1  Q2  
  Q1 t     t   ......
2   2  
Unit Hydrograph
• Hydrograph of surface runoff of a catchment
resulting from unit depth (usually 1 cm) of
rainfall excess (effective rainfall) occurring
uniformly over the watershed and at uniform
rate for a specified duration.
• A constant for the watershed
• Can be used to determine volume of direct
runoff of any storm occurring in the
catchment
• Assumptions in deriving Unit Hydrograph
– Uniform intensity of rainfall within a specified
duration
– Effective rainfall is uniformly distributed in the
watershed
– Base of time duration of the direct runoff
hydrograph is constant
– Direct runoff due to effective rainfall over the
watershed is always same, not vary with time
– Relationship between direct runoff and effective
rainfall is linear (Example: if ER of x cm generate y
m3 of direct runoff, 3x will generate 3y m3)
Derivation of unit hydrograph
• Step 1: Separate base flow from any method
• Step 2: Determination of the volume of direct
runoff (discussed earlier)
• Step 3: Determine the effective rainfall
Volume of Direct Runoff

Area of Watershed
• Step 4: Determination of ordinates of unit
hydrograph
Ordinate of DRH
OUHG 
ER
• Step 5: Plot the unit hydrograph
• Unit hydrograph can be used to get the
hydrographs for other rainfall events.
– Example : If 1 hour unit hydrograph is known, it
can be used to compute hydrograph of a three
hour event.
• Uses of unit hydrograph
– Development of flood hydrographs for extreme
rainfall events that can be used to design hydraulic
structures such as bridges, culverts etc.
– Flood forecasting and warning
– To extend flood flow records based on rainfall

You might also like