Scribd
Upload
42 views

Direct Connection Settings

To connect a computer to a network video recorder: 1. Open the network adapter settings and select "Properties" 2. In the IPV4 settings, change the IP address to be on the same network as the recorder, set the subnet mask and gateway. 3. Set the DNS servers to the gateway IP and the next available IP address.

Uploaded by

jamesmhebert
Copyright
© © All Rights Reserved
Available Formats
Download as PDF, TXT or read online on Scribd
42 views

Direct Connection Settings

To connect a computer to a network video recorder: 1. Open the network adapter settings and select "Properties" 2. In the IPV4 settings, change the IP address to be on the same network as the recorder, set the subnet mask and gateway. 3. Set the DNS servers to the gateway IP and the next available IP address.

Uploaded by

jamesmhebert
Copyright
© © All Rights Reserved
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 3

Networking computer to a recorder

1 STEP ONE IS TO OPEN YOUR ADAPTER SETTINGS.


1. First locate your network connection in the windows tool bar.

2. Right click on the network connection and select “Open Network and Sharing Center”

3. In the Network and Sharing Center, on the left hand side click on “Change adapter settings”
4. Once the adapter settings menu comes up, locate your wired network connect and right click on
it. In the right click menu select “Properties”

5. In the properties for the adapter locate and select “Internet protocol version 4 (IPV4)” and
double click it to load the IPV4 settings.
6. Once changing the IPV4 settings change the ip address from “Auto obtain IP address” to “Use
the following IP:” set the computers ip address up on the first line to something on the same ip
scheme as the recorder is on (default is 192.168.0.30 in the unit so use something like
192.168.0.250 for your computer) next tab down to subnet mask and let it auto fill in
255.255.255.0 for you, next tab down to the gateway and put in the same gateway that is set in
the recorder (default is 192.168.0.1). On your computer for the DNS servers at the bottom for
the primary server use your gateway ip address (192.168.0.1 is default) and then for the
secondary use the Ip address above the gateway (IE: 192.168.0.2). Once the settings for your
computers network card are set save and exit this menu. Once everything is saved you should
be then able to access the recorder on the web using the recorders IP address (Default is
192.168.0.30) or on any Uniview software.

7. When your demo is over make sure to go back to your computers IPV4 settings and change the
settings back to “Obtain an IP address automatically” so that when you plug in to a main
network later your connection will work for getting internet.

You might also like