Scribd
Upload
32 views15 pages

Indraprastha Institute of Information Technology Delhi Department of Electronics & Communication Engineering

1. The document is a lab report for a circuit theory and devices course. It details an experiment performed on a transformer to analyze efficiency and harmonic distortion under varying loads and input voltages. 2. Key measurements recorded include voltage, current, power, efficiency, and harmonic analysis at the primary and secondary windings. 3. The conclusions indicate that efficiency decreases with increasing resistance or voltage, and that using a switch increases harmonic distortion compared to without a switch. The DC supply was found to have negligible ripple.

Uploaded by

Ankit Garg
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
32 views15 pages

Indraprastha Institute of Information Technology Delhi Department of Electronics & Communication Engineering

1. The document is a lab report for a circuit theory and devices course. It details an experiment performed on a transformer to analyze efficiency and harmonic distortion under varying loads and input voltages. 2. Key measurements recorded include voltage, current, power, efficiency, and harmonic analysis at the primary and secondary windings. 3. The conclusions indicate that efficiency decreases with increasing resistance or voltage, and that using a switch increases harmonic distortion compared to without a switch. The DC supply was found to have negligible ripple.

Uploaded by

Ankit Garg
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 15

INDRAPRASTHA INSTITUTE of

INFORMATION TECHNOLOGY
DELHI

Department of
Electronics & Communication Engineering

Circuit Theory and Devices

Dr. Shobha Sundar Ram

Lab_5: Transformer
Week_6

Student Name – Ankit Garg


Roll No. - 2019146
Date – 6/10/2020
2|Page
1. 5 1.02A 5.2019W 147.23mA 241.15 -23.91W 21.756
2. 5 1.0201A 5.2027W 156.9mA 253 -27.10W 19.1981
3. 5 1.0201A 5.2035W 154.57mA 264.5 -27.35 19.0255
4. 5 1.0202A 5.2042W 152.99mA 276 -27.6W 18.855
5. 5 1.0203A 5.2049W 155mA 287.5 -28.4W 18.3271
6. 5 1.0203A 5.2056W 157.65mA 299 -30.86W 16.8684

Plots:
1) Schematic of the circuit :
4|Page

2)
5)
Peak Voltage = 5.2489 V
6) i) First Peak :

Peak Value = -16.071 db

8|Page
Frequency = 1.4111 hz

ii) Second Peak :


Peak Value = -20.6869 db
Frequency = 2.464 hz

iii) Third peak :


Frequency = 3.5265837Hz
Peak Value = -23.777 db

iv) Fourth peak :

Frequency = 4.47803Hz
Peak Value = -25.815928db
v) Fifth peak :

Frequency = 5.464265Hz
Peak Value = -27.594294db

7)

i) First peak :
Peak Value = -78.152028db
Frequency = 972.6720Hz

10 | P a g e
ii) Second peak :
Peak Value = -80.8883db
Frequency = 1.5579441KHz

iii) Third peak :


Peak Value = -84.98152db
Frequency = 2.0999958KHz

iv) Fourth peak :


Peak value = -86.294341db
Frequency = 2.7201703KHz

v) Fifth peak :
Peak value = -88.761db
Frequency = 3.297304KHz
Conclusions: If we increase resistance the efficiency will decrease
and if we increase the voltage the efficiency will again decrease.
In the case of a switch we can see that harmonic will increase
whereas without switch harmonics decreases. The 5V DC Supply
has negligible ripple. Maximum power efficiency is achieved at 5
ohm.

12 | P a g e
13 | P a g e

You might also like