Scribd
Upload
136 views

FCB1010 Programming

This document provides instructions for setting up an expression pedal on a Behringer FCB1010 controller to control a parameter on a Digitech GSP2101 effects processor. The steps are: 1. Program the FCB1010 patch to send MIDI CC12 messages from expression pedal A, with a range of 0-127. 2. In a GSP2101 patch, link the desired parameter to receive MIDI CC12 messages, and set the minimum and maximum values. 3. The expression pedal on the FCB1010 can now control the linked parameter on the GSP2101.

Uploaded by

ctrl.z.jones
Copyright
© © All Rights Reserved
Available Formats
Download as TXT, PDF, TXT or read online on Scribd
136 views

FCB1010 Programming

This document provides instructions for setting up an expression pedal on a Behringer FCB1010 controller to control a parameter on a Digitech GSP2101 effects processor. The steps are: 1. Program the FCB1010 patch to send MIDI CC12 messages from expression pedal A, with a range of 0-127. 2. In a GSP2101 patch, link the desired parameter to receive MIDI CC12 messages, and set the minimum and maximum values. 3. The expression pedal on the FCB1010 can now control the linked parameter on the GSP2101.

Uploaded by

ctrl.z.jones
Copyright
© © All Rights Reserved
Available Formats
Download as TXT, PDF, TXT or read online on Scribd
You are on page 1/ 1

HOW TO SET UP BEHRINGER FCB1010 AND DIGITECH GSP2101

EXPRESSION PEDALS

general hints

- make sure your fcb has the latest firmware, at least 2.3
- recalibrate the expression pedals. they often work faultily or not at
all, when the fcb is shipped
- get yourself ed dixon´s editor
- i suggest you to do some global and general programming on the fcb, then
do the rest on the 2101 using the mapping function

programming the fcb patch

choose a patch (say bank 0, patch 1)


press and hold [down] for three seconds to enter edit mode
press [up] so that the [select]led is on. now you are asked to determine, which
functions you want this patch to perform
the switches [8] and [9] refer to the exppedals A and B. to activate exppedal A ,
hold switch [8] until its led is on.
now press the switch again so that it blinks
press [up], so that the [number]led is on. the now blinking number in the display
indicates the controller# that will be sent by the exppedal. basically you can
choose any; you just will have to choose the same # on the 2101 later. let´s say
12.
press [up]. the number in the display is the minimum value that will be sent.
change it to “00”.
pressing [up] again will allow you to choose the maximum value. choose “127”.
press [up] to confirm.
press [down] for three seconds to leave edit mode.

programming the 2101 patch

select the patch, in which you want to use the exppedal


scroll to the window that shows the parameter, that you want have the fcb control
press the functionswitch that sets the cursor to this very parameter
press [midi]
press [>]. the display reads: “[insert parameter here] not linked”
turn the jogwheel until the display reads “[insert parameter here] links to MIDI
CC12” (the controller# that we have set the fcb-pedal to)
press functionswitch2 and determine minimum and maximum values
press [midi] to return to play-mode
save the patch

done.

You might also like