Scribd
Upload
101 views

Basic Machine Design Assignment

The document provides a tutorial on basic machine design. It gives an example of calculating the size of a weld needed to carry a 10 kN load on a bracket without exceeding an allowable shear stress of 80 MPa. The answer provided is that the required weld size is 10.83 mm.

Uploaded by

raj
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
101 views

Basic Machine Design Assignment

The document provides a tutorial on basic machine design. It gives an example of calculating the size of a weld needed to carry a 10 kN load on a bracket without exceeding an allowable shear stress of 80 MPa. The answer provided is that the required weld size is 10.83 mm.

Uploaded by

raj
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
You are on page 1/ 1

BASIC MACHINE DESIGN TUTORIAL SHEET

1. A bracket, as shown in Figure below, carries a load of 10 kN. Find the size of the weld if the allowable shear stress is
not to exceed 80 MPa.

Ans. 10.83 mm

BASIC MACHINE DESIGN TUTORIAL SHEET

1. A bracket, as shown in Figure below, carries a load of 10 kN. Find the size of the weld if the allowable shear stress is
not to exceed 80 MPa.

Ans. 10.83 mm

BASIC MACHINE DESIGN TUTORIAL SHEET

1. A bracket, as shown in Figure below, carries a load of 10 kN. Find the size of the weld if the allowable shear stress is
not to exceed 80 MPa.

Ans. 10.83 mm

You might also like