Scribd
Upload
84 views1 page

Tds Rev 3.0: Technical Data Sheet: Thermax™ Peek 3D Printing Filament

This document provides technical data and properties of ThermaXTM PEEK 3D printing filament. It lists physical, mechanical, thermal, and fire testing properties and standards. Printed specimen conditions are also specified.

Uploaded by

nhzaidi
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
84 views1 page

Tds Rev 3.0: Technical Data Sheet: Thermax™ Peek 3D Printing Filament

This document provides technical data and properties of ThermaXTM PEEK 3D printing filament. It lists physical, mechanical, thermal, and fire testing properties and standards. Printed specimen conditions are also specified.

Uploaded by

nhzaidi
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 1

TDS Rev 3.

Technical Data Sheet: ThermaX™ PEEK 3D Printing Filament

Physical Properties Standard Unit Metric


Density ISO 1183 g/cc 1.30

Mechanical Properties Standard Unit Metric


Tensile Strength ISO 527 MPa 100
Tensile Modulus ISO 527 MPa 3720
Tensile Elongation ISO 527 % 28
Flexural Strength ISO 178 MPa 130
Flexural Modulus ISO 178 MPa 2700

Thermal Properties Standard Unit Metric


Glass Transition Temperature
DSC °C 143
(Tg)
Deflection Temperature at 0.45
ISO 75 °C 140
MPa (66psi)

Fire Testing* Standard Unit Typical Value


Flamability Rating (*Base Resin) UL 94 - V-0 @1.5mm

Printed Specimen Conditions


Printer: Open Source FDM/FFF
Nozzle: 0.4mm
Layer Height: 0.25mm
Infill: 100%, +/- 45°
Extrusion Temp: 380-400°C
Bed Temp: 130-140°C
Specimen Orientation: XY Flat
Disclaimer: The technical data contained on this data sheet is
furnished without charge or obligation and accepted at the

www.3dxtech.com
recipient’s sole risk. This data should not be used to establish
specifications limits or used alone as the basis of design. The
data provided is not intended to substitute any testing that may
be required to determine fitness for any specific use.

You might also like